CISCO-DOCS-REMOTE-QUERY-MIB Table View

This table contains the status of the cable modems that 
are polled by the CMTS CM Poller. The information will be 
overwritten when a new polling cycle starts.
          
The removal of CM from the list or adding a new CM to the 
list won't be reflected until the next polling cycle.
          
Depending on how many CMs that the poller is polling, 
polling this table constantly can be quite expensive; 
Therefore, it is best to poll upon receipt of the 
cdrqCmtsCmRQDoneNotification. As a hedge against lost 
notifications, periodic background polling should 
be performed.  Howerver, excessive polling could 
degrade performance.

cdrqCmtsCmStatusEntry row .1.3.6.1.4.1.9.10.59.1.2.1.1

A list of the cable modem's attributes
that are polled by a CMTS.

Indexes

CISCO-DOCS-EXT-MIBcdxCmCpeMacAddress

Column	Syntax	OID
cdrqCmtsCmDownChannelPower The CM's received power level. This object may be set to zero if the CM does not support power level measurement. If the CM downstream interface is down, this object either returns the most current valu…	dBmVDOCS-IF-MIBTenthdBmV	.1.3.6.1.4.1.9.10.59.1.2.1.1.1
cdrqCmtsCmStatusTxPower The operational transmit power for the CM upstream channel.	dBmVDOCS-IF-MIBTenthdBmV	.1.3.6.1.4.1.9.10.59.1.2.1.1.2
cdrqCmtsCmUpChnlTxTimingOffset A measure of the current round trip time. Used for timing of CM upstream transmissions to ensure synchronized arrivals at the CMTS.	SNMPv2-SMIUnsigned32 Type Constraints: range: 0..4294967295	.1.3.6.1.4.1.9.10.59.1.2.1.1.3
cdrqCmtsCmSigQSignalNoise Signal/Noise ratio as perceived for the CM downstream channel.	dBDOCS-IF-MIBTenthdB	.1.3.6.1.4.1.9.10.59.1.2.1.1.4
cdrqCmtsCmSigQMicroreflections Total microreflections including in-channel response as perceived on the CM downstream, measured in dBc below the signal level. This object is not assumed to return an absolutely accurate value, but is …	dBcInteger32 Constraints: range: 0-255	.1.3.6.1.4.1.9.10.59.1.2.1.1.5
cdrqCmtsCmPollTime The value of sysUpTime when this CM entry was polled. If this value is larger than the cdrqCmtsCmPollerStopTime, either by receiving it from the cdrqCmtsCmRQDoneNotification or by polling the object i…	SNMPv2-TCTimeStamp Based On: SNMPv2-SMITimeTicks Description: The value of the sysUpTime object at which a specific occurrence happened. The specific occurrence must be defined in the description of any object defined using this type. If sysUpTime is reset t…	.1.3.6.1.4.1.9.10.59.1.2.1.1.6