A3Com-IPextns-r5-MIB Table View

This table is an extension of the ipNetToMediaTable
from mibII.  Currently, this table contains objects
for controlling MAC header formats and for controlling
proxy ARP for each entry.

a3IPntmExtEntry row .1.3.6.1.4.1.43.2.6.7.1

Each entry in this table corresponds to an entry in the
ipNetToMediaTable. Additional columnar objects are defined
in this table that are not in the original table.

Indexes

a3IPntmIfIndex a3IPntmNetAddress

Column	Syntax	OID
a3IPntmIfIndexmandatory The interface on which this entry's equivalence is effective.	Integer32 Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.43.2.6.7.1.1
a3IPntmNetAddressmandatory The IpAddress corresponding to the media-dependent physical address.	RFC1155-SMIIpAddress Type Constraints: range: 4	.1.3.6.1.4.1.43.2.6.7.1.2
a3IPntmHdrFormatmandatory The header format to be used when sending packets to the destination specified by this table entry. This parameter only applies to networks that support MAC addresses. Entries that correspond to other network types h…	Enumerationr/w Enumerated Values: 1 other 2 ethernet 3 ieee 4 snap	.1.3.6.1.4.1.43.2.6.7.1.3
a3IPntmProxyArpmandatory If this object is set to proxy (1), the system will respond to ARP requests for the IP address of this entry. If this object is set to noProxy (2), no response will be sent.	Enumerationr/w Enumerated Values: 1 proxy 2 noProxy	.1.3.6.1.4.1.43.2.6.7.1.4

This table contains the IP addresses assigned to each
IP port.

a3IPaddrConfigEntry row .1.3.6.1.4.1.43.2.6.8.1

Each entry contains a single IP address and
parameters relating to routing IP over a specific port.

Indexes

a3IPaddrConfigPort a3IPaddrConfigAddr

Column	Syntax	OID
a3IPaddrConfigPortmandatory The port to which this entry applies.	Integer32 Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.43.2.6.8.1.1
a3IPaddrConfigAddrmandatory The IP address to which this entry applies.	RFC1155-SMIIpAddress Type Constraints: range: 4	.1.3.6.1.4.1.43.2.6.8.1.2
a3IPaddrConfigTypemandatory When multiple IP addresses are configured for a single interface, this object is used to determine which address is the 'primary' address. 'Primary' addresses are used as the source IP address in packets sent from that…	Enumerationr/w Enumerated Values: 1 primary 2 secondary	.1.3.6.1.4.1.43.2.6.8.1.3
a3IPaddrConfigNetMaskmandatory The subnet mask associated with the IP address of this entry. The value of the mask is an IP address with all the network bits set to 1 and all the host bits set to 0. If this is not specified, the syste…	RFC1155-SMIIpAddressr/w Type Constraints: range: 4	.1.3.6.1.4.1.43.2.6.8.1.4
a3IPaddrConfigBcastAddrmandatory The value of the least-significant bit in the IP broadcast address used for sending datagrams on the logical interface associated with the IP address of this entry.	Integer32r/w Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.43.2.6.8.1.5
a3IPaddrConfigMtumandatory The size of the largest IP datagram which is supported by the logical interface associated with the IP address of this entry. If this is not specified, the system will select a value based on the interfac…	Integer32r/w Constraints: range: 68-32767	.1.3.6.1.4.1.43.2.6.8.1.6
a3IPaddrConfigStatusmandatory This object is used to add and delete entries in this table. See the notes describing RowStatus at the beginning of this MIB.	RowStatusr/w Type Values: 1 active 2 notInService 3 notReady 4 createAndGo 5 createAndWait 6 destroy	.1.3.6.1.4.1.43.2.6.8.1.7

An extension to the ipForwardTable.

a3IPforwardExtEntry row .1.3.6.1.4.1.43.2.6.9.1

Each entry in this table corresponds to a single
entry in the ipForwardTable. An additional columnar
object has been defined to indicate whether a dynamically
learned route may take precendence of a particular
static r…

Indexes

a3IPforwardExtDest a3IPforwardExtProto a3IPforwardExtPolicy a3IPforwardExtNextHop

Column	Syntax	OID
a3IPforwardExtDestmandatory The destination IP address of this route. This is identical to ipForwardDest.	RFC1155-SMIIpAddress Type Constraints: range: 4	.1.3.6.1.4.1.43.2.6.9.1.1
a3IPforwardExtProtomandatory The routing mechanism via which this route was learned.	Enumeration Enumerated Values: 1 other 2 local 3 netmgmt 4 icmp 5 egp 6 ggp 7 hello 8 rip 9 is-is 10 es-is 11 ciscoIgrp 12 bbnSpfIgp 13 ospf 14 bgp 15 idpr	.1.3.6.1.4.1.43.2.6.9.1.2
a3IPforwardExtPolicymandatory The general set of conditions that would cause the selection of one multipath route (set of next hops for a given destination) is referred to as 'policy'. Unless the mechanism indicated by ipForwardPr…	Integer32 Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.43.2.6.9.1.3
a3IPforwardExtNextHopmandatory On remote routes, the address of the next system en route. Otherwise, 0.0.0.0	RFC1155-SMIIpAddress Type Constraints: range: 4	.1.3.6.1.4.1.43.2.6.9.1.4
a3IPforwardExtOverridemandatory This object is used to identify those static routes that may be overridden by dynamically learned routes. For those entries in this table that represent dynamically learned routes, this object will have the value noOver…	Enumerationr/w Enumerated Values: 1 override 2 noOverride	.1.3.6.1.4.1.43.2.6.9.1.5

This table contains ARP configuration information.

a3IParpConfigEntry row .1.3.6.1.4.1.43.2.6.13.1

Each entry in this table contains port-specific
ARP configuration information.

Indexes

a3IParpPortIndex

Column	Syntax	OID
a3IParpPortIndexmandatory The port index to which these entries apply.	Integer32 Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.43.2.6.13.1.1
a3IParpProxyCtlmandatory This object applies to ARP requests for networks or subnetworks that are in the IP routing table. When this is the case, this system will respond to the request with the MAC address of this system's interface if the v…	Enumerationr/w Enumerated Values: 1 proxy 2 noProxy	.1.3.6.1.4.1.43.2.6.13.1.2
a3IParpHoldTimemandatory This object determines the amount of time, in hours, an entry can stay in the ARP table. When the specified time elapses, the entry is deleted. When one sixteenth of the time elapses, ARP considers this entry aged. W…	Integer32r/w Constraints: range: 1-24	.1.3.6.1.4.1.43.2.6.13.1.3
a3IParpReqFormatmandatory This parameter specifies the Ethernet header format used for ARP requests. If this is set to ethernet (1), ARP sends requests with an Ethernet Version 2 header. If this is set to snap (2), ARP sends requests with the …	Enumerationr/w Enumerated Values: 1 ethernet 2 snap 3 both 128 auto 129 ethAuto 130 snapAuto 131 bothAuto	.1.3.6.1.4.1.43.2.6.13.1.4
a3IParpRemAddrmandatory The value of this object reflects the IP address that is assigned to the boundary router that is attached to this port. This address is used when a RARP request is received from that boundary router. For…	RFC1155-SMIIpAddressr/w Type Constraints: range: 4	.1.3.6.1.4.1.43.2.6.13.1.5
a3IParpInvCtlmandatory This object specifies whether inverse arp is enabled on this port. Note, this affects only Frame Relay ports.	Enumerationr/w Enumerated Values: 1 enabled 2 disabled	.1.3.6.1.4.1.43.2.6.13.1.6

This table contains a set of IP network address
to SMDS Group Address pairings.

a3IPsmdsGaEntry row .1.3.6.1.4.1.43.2.6.14.1

Each entry in this table contains a single
IP network address to SMDS Group Address
mapping. This is used in applications running
IP over SMDS.

Indexes

a3IPsmdsGaIpNet

Column	Syntax	OID
a3IPsmdsGaIpNetmandatory This is an IP network address for which there is a corresponding SMDS Group Address.	RFC1155-SMIIpAddress Type Constraints: range: 4	.1.3.6.1.4.1.43.2.6.14.1.1
a3IPsmdsGamandatory This is the SMDS Group Address that corresponds to the IP network address identified by a3IPsmdsGaIpNet.	SMDSAddressr/w Type Constraints: range: 8	.1.3.6.1.4.1.43.2.6.14.1.2
a3IPsmdsGaStatusmandatory This object is used to add and delete entries in this table. See the notes describing RowStatus at the beginning of this MIB.	RowStatusr/w Type Values: 1 active 2 notInService 3 notReady 4 createAndGo 5 createAndWait 6 destroy	.1.3.6.1.4.1.43.2.6.14.1.3

This table contains a set of X25 configuration
parameters relating to routing IP over x25 networks.

a3IPx25configEntry row .1.3.6.1.4.1.43.2.6.15.1

Each entry contains a set of x25 configuration
parameters relating to routing IP over a specific port.

Indexes

a3IPx25configPort

Column	Syntax	OID
a3IPx25configPortmandatory The port number to which this table entry applies.	Integer32 Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.43.2.6.15.1.1
a3IPx25configPIDmandatory The protocol ID that is included in all outgoing IP packets sent over the x25 port associated with this table entry.	Integer32r/w Constraints: range: 1-255	.1.3.6.1.4.1.43.2.6.15.1.2
a3IPx25configQueueSizeobsolete The maximum number of packets that can be queued for a specific DTE address when the virtual circuit or the x25 port is congested. NOTE: this object is no longer supported by NETBuilders running sw versio…	Integer32r/w Constraints: range: 1-128	.1.3.6.1.4.1.43.2.6.15.1.3
a3IPx25configVClimitobsolete The maximum number of virtual circuits that can be established concurrently for IP routing. NOTE: this object is no longer supported by NETBuilders running sw version 8.0 and greater.	Integer32r/w Constraints: range: 0-15	.1.3.6.1.4.1.43.2.6.15.1.4
a3IPx25configVCtimerobsolete The maximum amount of time, in minutes, that can elapse when there is no activity on the x25 virtual circuit before it is cleared. This applies to the first virtual circuit established for a particular DTE address. IF…	Integer32r/w Constraints: range: 1-512	.1.3.6.1.4.1.43.2.6.15.1.5
a3IPx25configProfIDmandatory This object specifies the X25 User ProfileID to be used for selecting a Virtual Circuit to send IP Packets. Range is 0..255. If the value specified is 0 then use the DTE Profile ID	Integer32r/w Constraints: range: 0-255	.1.3.6.1.4.1.43.2.6.15.1.6

This table contains ICMP configuration information.

a3IPicmpGenEntry row .1.3.6.1.4.1.43.2.6.18.1

Each entry in this table contains port-specific
ICMP configuration information.

Indexes

a3IPicmpGenIfIndex

Column	Syntax	OID
a3IPicmpGenIfIndexmandatory The port to which this entry applies.	Integer32 Type Constraints: range: -2147483648..2147483647	.1.3.6.1.4.1.43.2.6.18.1.1
a3IPicmpGenRedirectmandatory This object controls whether ICMP issues ReDirect packets on this port.	Enumerationr/w Enumerated Values: 1 redirect 2 noRedirect	.1.3.6.1.4.1.43.2.6.18.1.2
a3IPicmpGenDestUnreachmandatory This object controls whether ICMP issues Destination Unreachable packets on this port.	Enumerationr/w Enumerated Values: 1 destUnreachable 2 noDestUnreachable	.1.3.6.1.4.1.43.2.6.18.1.3
a3IPicmpGenTimeExceedmandatory This object controls whether ICMP issues Time Exceeded packets on this port.	Enumerationr/w Enumerated Values: 1 timeExceed 2 noTimeExceed	.1.3.6.1.4.1.43.2.6.18.1.4