wtWebioEA2x2LoadControlEnable
Webio-Digital-MIB-US ·
.1.3.6.1.4.1.5040.1.2.13.3.1.4.3
Object
scalar
mandatory
r/w
OctetString
Here the function of automatic load control can be enabled. All output were tested in
pairs (0-1). If an error occours at one output,
both output of an pair will be switched of. For a properly function of the load control
each output of a pair have to has a load. If there is no existing load, a pull down resistor
can be used.
Outputs with no load are automaticly detected and not part of the control function.
The OCTETS are interpreted bit-by-bit, with each bit corresponding to an output.
Bit 0 corresponds to the LSB.
Octet 1: unused
Octet 2: unused
Octet 3: unused
Octet 4:
Bit 1-7: unused
Bit 0 : Load Control enable
Context
- MIB
- Webio-Digital-MIB-US
- OID
.1.3.6.1.4.1.5040.1.2.13.3.1.4.3- Type
- scalar
- Access
- readwrite
- Status
- mandatory
- Parent
- wtWebioEA2x2OutputMode
- Siblings
- 2
Syntax
OctetString
Values & Constraints
No enumerated values or constraints recorded.
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| wtWebioEA2x2OutputModeTable mandatory Table of output mode configurations dependent on the output indices. | table | - | .1.3.6.1.4.1.5040.1.2.13.3.1.4.1 |
| wtWebioEA2x2SafetyTimeout mandatory After this period of time (multiple of 100ms) without receiving data
outputs switch to their Safety States. For each output a independend safety state
could be defined. | scalar | Integer32 | .1.3.6.1.4.1.5040.1.2.13.3.1.4.2 |