wtWebioEA2x2ERPLCShutDownView

Webio-Digital-MIB-US · .1.3.6.1.4.1.5040.1.2.25.3.1.5.5
MIB view Table view

Object

scalar mandatory r/w OctetString 
Here the result of the automatic load control shut down can be read. All outputs remain switched of,
until a zero is written into this variable. But previously all loads should be inspected.
High current (short circuit), a broken supply line or a defect load (i.e. lamp) may be a shut down reason.
If no load is detected, the load control unit suspend automaticly the control of the corresponding output pair.
All controlled output could be identified reading the variable wtWebioEA2x2ERPLoadControlEnable.
The OCTETS are interpreted bit-by-bit, with each bit corresponding to an ouput.
Bit 0 corresponds to the LSB.
          
Octet 1: unused
Octet 2: unused
Octet 3: unused
Octet 4: Bit 0-1: outputs 0-1.

Context

MIB
Webio-Digital-MIB-US
OID
.1.3.6.1.4.1.5040.1.2.25.3.1.5.5
Type
scalar
Access
readwrite
Status
mandatory
Parent
wtWebioEA2x2ERPAlarm
Siblings
4

Syntax

OctetString

Values & Constraints

Object Constraints
range: 8-8

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
wtWebioEA2x2ERPAlarmCount mandatory
Number of independent alarms.
scalarInteger32.1.3.6.1.4.1.5040.1.2.25.3.1.5.1
wtWebioEA2x2ERPAlarmIfTable mandatory
List of alarm indices.
table-.1.3.6.1.4.1.5040.1.2.25.3.1.5.2
wtWebioEA2x2ERPAlarmTable mandatory
List of settings depending on the alarm number.
table-.1.3.6.1.4.1.5040.1.2.25.3.1.5.3
wtWebioEA2x2ERPLoadControlView mandatory
Here the result of automatic load control can be read. All output were tested in pairs (0-1). If an error occours at one output, both output of an pair will be switched of. For a…
scalarOctetString.1.3.6.1.4.1.5040.1.2.25.3.1.5.4