wtWebioEA2x2ERP-24VLoadControlEnable
Webio-Digital-MIB-US ·
.1.3.6.1.4.1.5040.1.2.31.3.1.4.3
Object
scalar
mandatory
r/w
OctetString
Here the function of automatic load control can be enabled. All output were tested in
pairs (0-1). If an error occours at one output,
both output of an pair will be switched of. For a properly function of the load control
each output of a pair have to has a load. If there is no existing load, a pull down resistor
can be used.
Outputs with no load are automaticly detected and not part of the control function.
The OCTETS are interpreted bit-by-bit, with each bit corresponding to an output.
Bit 0 corresponds to the LSB.
Octet 1: unused
Octet 2: unused
Octet 3: unused
Octet 4:
Bit 1-7: unused
Bit 0 : Load Control enable
Context
- MIB
- Webio-Digital-MIB-US
- OID
.1.3.6.1.4.1.5040.1.2.31.3.1.4.3- Type
- scalar
- Access
- readwrite
- Status
- mandatory
- Parent
- wtWebioEA2x2ERP-24VOutputMode
- Siblings
- 3
Syntax
OctetString
Values & Constraints
No enumerated values or constraints recorded.
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| wtWebioEA2x2ERP-24VOutputModeTable mandatory Table of output mode configurations dependent on the output indices. | table | - | .1.3.6.1.4.1.5040.1.2.31.3.1.4.1 |
| wtWebioEA2x2ERP-24VSafetyTimeout mandatory After this period of time (multiple of 100ms) without receiving data
outputs switch to their Safety States. For each output a independend safety state
could be defined. | scalar | Integer32 | .1.3.6.1.4.1.5040.1.2.31.3.1.4.2 |
| wtWebioEA2x2ERP-24VPowerSupplyEnable mandatory Setting this enable bit turns on the intarnal 24V power supply of the outputs.
All currents out must not exceed 150mA. At overcurrent condition the power supply will
be shut down … | scalar | OctetString | .1.3.6.1.4.1.5040.1.2.31.3.1.4.4 |