wtWebioEA24oemLoadControlEnable

Webio-Digital-MIB-US · .1.3.6.1.4.1.5040.1.2.14.3.1.4.3
MIB view Table view

Object

scalar mandatory r/w OctetString 
Here the function of automatic load control can be enabled. All output were tested in 
pairs (0-1, 2-3, 4-5, 6-7, 8-9, 10-11). If an error occours at one output,
both output of an pair will be switched of. For a properly function of the load control
each output of a pair have to has a load. If there is no existing load, a pull down resistor
can be used.
Outputs with no load are automaticly detected and not part of the control function.
The OCTETS are interpreted bit-by-bit, with each bit corresponding to an output. 
Bit 0 corresponds to the LSB.
Octet 1: unused
Octet 2: unused
Octet 3: unused
Octet 4:
	Bit 1-7: unused
        Bit 0  : Load Control enable

Context

MIB
Webio-Digital-MIB-US
OID
.1.3.6.1.4.1.5040.1.2.14.3.1.4.3
Type
scalar
Access
readwrite
Status
mandatory
Parent
wtWebioEA24oemOutputMode
Siblings
2

Syntax

OctetString

Values & Constraints

No enumerated values or constraints recorded.

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
wtWebioEA24oemOutputModeTable mandatory
Table of output mode configurations dependent on the output indices.
table-.1.3.6.1.4.1.5040.1.2.14.3.1.4.1
wtWebioEA24oemSafetyTimeout mandatory
After this period of time (multiple of 100ms) without receiving data outputs switch to their Safety States. For each output a independend safety state could be defined.
scalarInteger32.1.3.6.1.4.1.5040.1.2.14.3.1.4.2