igmpSnoopingQuerierInterval

WESTERMO-WEOS-MIB · .1.3.6.1.4.1.16177.2.1.3.4.2
MIB view Table view

Object

scalar r/w SNMPv2-SMIInteger32 
The IGMP Querier Interval (seconds). This interval will be used on all
interfaces where this unit acts as IGMP Querier, unless multicast routing
protocol specific or interface specific querier setting exist.
Currently, the following interval values are valid: 12, 30, 70 and 150 (seconds).

Context

MIB
WESTERMO-WEOS-MIB
OID
.1.3.6.1.4.1.16177.2.1.3.4.2
Type
scalar
Access
readwrite
Status
current
Parent
igmpSnooping
Siblings
4

Syntax

SNMPv2-SMIInteger32
Source
SNMPv2-SMIInteger32
Base type
Integer32

Values & Constraints

Type Constraints
range: -2147483648..2147483647

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
igmpSnoopingQuerierMode
The querierMode object controls the querier mode an IGMP snooping switch will operate in on IGMP Snooping enabled VLANs. If the switch does not have an IP address on a certain VLA…
scalarEnumeration.1.3.6.1.4.1.16177.2.1.3.4.1
staticMulticastRouterPorts
This is a comma-separated list of (LAN)port names, which specifies statically configured 'multicast router ports'. All layer-2 multicast traffic (known and unknown) should be forw…
scalarSNMPv2-TCDisplayString.1.3.6.1.4.1.16177.2.1.3.4.3
currentMulticastRouterPorts
This is a comma-separated list of portnames, which lists all ports operating as multicast router ports - both dynamically discovered (e.g., by reception of IGMP Queries) or static…
scalarSNMPv2-TCDisplayString.1.3.6.1.4.1.16177.2.1.3.4.4
igmpSnoopingVlanTable
A list of configuration entries for VLAN specific IGMP Snooping objects.
table-.1.3.6.1.4.1.16177.2.1.3.4.5