cfgNetEthBridge
WESTERMO-SW6-MIB ·
.1.3.6.1.4.1.16177.1.400.1.1.2.1.1.7
Object
If set to other than -1 the interface is part of bridge:
* -1: none
* 0: br0
* 1: br1
* X: brX
Bridges with an index >=100 are special bridges which forward
link local traffic. This can be used for wireless links in 4addr
mode which should act as a cable-replacement.
**Note:** Such a bridge may only contain 2 interfaces!
**Example**
* wlan0 and eth0 in br100, with eth1 as management interface.
Applies to AP and STA.
Context
- MIB
- WESTERMO-SW6-MIB
- OID
.1.3.6.1.4.1.16177.1.400.1.1.2.1.1.7- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- cfgNetEthernetTableEntry
- Table
- cfgNetEthernetTable
- Siblings
- 9
Syntax
SNMPv2-SMIInteger32
- Source
- SNMPv2-SMIInteger32
- Base type
Integer32
Values & Constraints
Type Constraints
range: -2147483648..2147483647
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cfgNetEthIndex Entry index of table. | column | Integer32 | .1.3.6.1.4.1.16177.1.400.1.1.2.1.1.1 |
| cfgNetEthTrunk This entry is active when `cfgNetEthVlanMode` is set to
**trunk(0)** or **nativeuntagged(3)**.
It specifies which 802.1q vlans are accepted ingress and egress on
th… | column | OctetString | .1.3.6.1.4.1.16177.1.400.1.1.2.1.1.10 |
| cfgNetEthTag This entry is active when `cfgNetEthVlanMode` is set to
**access(1)** or **nativeuntagged(3)**. It specifies which 802.1q
VLAN should be used for untagged ingress and egress traff… | column | Integer32 | .1.3.6.1.4.1.16177.1.400.1.1.2.1.1.11 |
| cfgNetEthVlanMode This entry specifies how the port should behave.
* **trunk(0):** A trunk port carries packets on one or more specified
VLANs specified in the cfgNetEthTrunk entry… | column | Enumeration | .1.3.6.1.4.1.16177.1.400.1.1.2.1.1.12 |
| cfgNetEthLldpEnabled When `cfgLldpEnabled` is enabled, this parameter controls if
the interface takes part in LLDP operation.
Applies to AP and STA. | column | Enumeration | .1.3.6.1.4.1.16177.1.400.1.1.2.1.1.15 |
| cfgNetEthName Name of the ethernet interface.
Applies to AP and STA. | column | OctetString | .1.3.6.1.4.1.16177.1.400.1.1.2.1.1.2 |
| cfgNetEthEnabled Ethernet interface disabled or enabled.
Applies to AP and STA. | column | Enumeration | .1.3.6.1.4.1.16177.1.400.1.1.2.1.1.3 |
| cfgNetEthAutoneg Enables or disables auto negotiation of the PHY.
* **forced(0):** Forces the speed and duplex defined by
`cfgNetEthSpeed`. Only 10Mbit and 100Mbit rates are
al… | column | Enumeration | .1.3.6.1.4.1.16177.1.400.1.1.2.1.1.8 |
| cfgNetEthSpeed Defines a bitmask containing the possible speed/duplex combinations.
* 0x01 (1) = 10Mbit/Half
* 0x02 (2) = 10Mbit/Full
* 0x04 (4) = 100Mbit/Half
* 0x08 (8) = 10… | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.16177.1.400.1.1.2.1.1.9 |