tnDot1agCfmMcLagConfigPropHoldTime
TN-IEEE8021-CFM-MIB ·
.1.3.6.1.4.1.7483.6.1.2.52.2.1.1.2
Object
column
r/w
seconds Unsigned32
The value of tnDot1agCfmMcLagConfigPropHoldTime specifies the duration, in
seconds, of a timer that is activated when an MC-LAG port or protocol
changes state. While the timer is active, no fault set or clear is
propagated to the MC-LAG SAP's CFM MEP.
The outstanding hold time can be monitored by polling the value of
sapEthCfmMcLagPropHoldTimeRemain for a particular SAP. When set to
the value zero (0), no delay in response to a port or protocol change
will be observed.
This object is meaningful only when tnDot1agCfmMcLagConfigStdbyInactive is
set to the value 'enabled (1)', otherwise an SNMP Set operation will
result in an inconsistentValue error and the result of an SNMP Get
operation will be undefined.
Context
- MIB
- TN-IEEE8021-CFM-MIB
- OID
.1.3.6.1.4.1.7483.6.1.2.52.2.1.1.2- Type
- column
- Access
- readwrite
- Status
- current
- Units
- seconds
- Parent
- tnDot1agCfmMcLagConfigEntry
- Table
- tnDot1agCfmMcLagConfigTable
- Siblings
- 1
Syntax
seconds Unsigned32
Values & Constraints
Object Constraints
range: 0-60
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| tnDot1agCfmMcLagConfigStdbyInactive The value of tnDot1agCfmMcLagConfigStdbyInactive specifies whether or not
ETH-CFM MEPs configured on Multi-Chassis LAG ports are aware of MC-LAG
port active/standby states.
… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.7483.6.1.2.52.2.1.1.1 |