tmnxOamPmCfgThrLossChliClear

The value of tmnxOamPmCfgThrLossChliClear specifies the clear
threshold for Consecutive High Loss Intervals (CHLIs).
              
tmnxOamPmCfgThrLossChliClear is the clear threshold for the list of
counters specified in the tmnxOamPmCfgThrLossChliRaise DESCRIPTION
clause.
              
For example, suppose:
1.  OAM-PM loss TCAs are enabled for the 'mi15minutes(2)' measurement
interval of the OAM-PM session OAM_PM_Eth_session_1 (using
tmnxOamPmCfgMeasIntvlLossTCAs and tmnxOamPmCfgMeasIntvlTCAs).
2.  tmnxOamPmCfgThrLossChliClear is set to 5 for the indices
{OAM_PM_Eth_session_1, 'slm(2)', 'forward(1)'}.
3.  A previous 15 minute interval belonging to OAM_PM_Eth_session_1's
SLM test generated a CHLI Raise TCA for the forward direction (see
tmnxOamPmCfgThrLossChliRaise).  The TCA has not been cleared.
4.  The just-closed 15-minute interval has an forward CHLI count for
the forward direction (i.e. tmnxOamPmStsLossSlmChliFwd) of 5, or less.
              
Then, SROS generates a CHLI Clear TCA (using tmnxOamPmThrClear) for
the 15-minute interval, for the forward direction.
              
If tmnxOamPmCfgThrLossChliRaise>0 AND tmnxOamPmCfgThrLossChliClear>=0,
CHLI Clear TCAs can be generated for the specified indices.  In this
case, the maximum number of CHLI TCAs that will be generated for the
specified indices across (for example) two 15 minute intervals is two:
Raise and Clear.
              
If tmnxOamPmCfgThrLossChliRaise>0 AND tmnxOamPmCfgThrLossChliClear=-1,
no CHLI Clear TCAs will be generated for the specified indices.  In
this case, the maximum number of CHLI TCAs that will be generated for
the specified indices across (for example) two 15 minute intervals is
two: Raise and Raise.
              
tmnxOamPmCfgThrLossChliRaise must be greater than
tmnxOamPmCfgThrLossChliClear.  Exception: the combination
tmnxOamPmCfgThrLossChliRaise=-1 and tmnxOamPmCfgThrLossChliClear=-1 is
supported.
              
tmnxOamPmCfgThrLossChliClear and tmnxOamPmCfgThrLossChliClear must be
set in the same SNMP Set PDU.

MIB

TIMETRA-OAM-PM-MIB

OID

.1.3.6.1.4.1.6527.3.1.2.92.1.3.14.1.3

Type

column

Access

readwrite

Status

current

Parent

tmnxOamPmCfgThrLossFwBwAgEntry

Table

tmnxOamPmCfgThrLossFwBwAgTable

Siblings

10