saRgDeviceResetDefaultEnable
SA-RG-MIB ·
.1.3.6.1.4.1.1429.79.2.1.1.2
Object
This object controls the reset to factory default functionality
of the gateway. This prevents the local user from using the reset
switch to gain access to the setup pages using the default user
name and password. The objective is to prevent theft of service
from a user who reconfigures the device to add users or change
wireless settings.
Enable (object set to true):
1. Momentary press of the Reset Switch (<5 seconds)
DOCSIS restart of the modem (reboot, no reset to factory
default values).
2. Pressing the reset switch for >5 seconds
Reboots and resets of all values (modem and router) to
factory default.
Disable (object set to false):
1. Momentary press of the Reset Switch (<5 seconds)
DOCSIS restart of the modem (reboot, no reset to factory
default values).
2. Pressing the reset switch for >5 seconds
Modem reboots and resets only the cable modem settings to
factory default values. The router settings should remain and
should not NOT reset to factory default.
Context
- MIB
- SA-RG-MIB
- OID
.1.3.6.1.4.1.1429.79.2.1.1.2- Type
- scalar
- Access
- readwrite
- Status
- current
- Parent
- saRgDeviceBase
- Siblings
- 7
Values & Constraints
Type Values
1 | true |
2 | false |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| saRgDeviceMode Defines the mode of operation for the device.
This parameter is stored in non-vol and is multiSsid(1) by default.
Setting this object via SNMP will cause
the unit to reboot.
… | scalar | Enumeration | .1.3.6.1.4.1.1429.79.2.1.1.1 |
| saRgDeviceFactoryReset Set routerAndWifi(1) to restore default settings of both the router and wifi.
Set routerOnly(2) to restore default settings of the router.
Set wifi(3) to restore default settings … | scalar | Enumeration | .1.3.6.1.4.1.1429.79.2.1.1.1002 |
| saRgDeviceRemoteWebAccessPort Defines what port to use for the WAN IP address of the gateway
to be able to access RG web pages.
This value is to be stored in non-vol and will persist across reboots.
Only a fac… | scalar | INET-ADDRESS-MIBInetPortNumber | .1.3.6.1.4.1.1429.79.2.1.1.4 |
| saRgDeviceLanLanIsolation This MIB is only available in D3.0 products.
This MIB does not take effect if the modem is in VLAN mode i.e if saRgIpMgmtLanMode.32=vlan(5).
Lan-Lan Isolation allows you block IP … | scalar | Enumeration | .1.3.6.1.4.1.1429.79.2.1.1.6 |
| saRgDeviceLanWlanIsolation This MIB is only available in D3.0 products.
This MIB does not take effect if the modem is in VLAN mode i.e if saRgIpMgmtLanMode.32=vlan(5).
Lan-Wlan Isolation allows you block IP… | scalar | Enumeration | .1.3.6.1.4.1.1429.79.2.1.1.7 |
| saRgDeviceIpv6Trans This MIB will control which IPv6 transition technology is enabled on the device.
After setting this MIB to disable in the config file, IPv4 traffic will pass normally
thro… | scalar | Enumeration | .1.3.6.1.4.1.1429.79.2.1.1.8 |
| saRgDeviceIpv6Passthrough This MIB controls IPv6 passthrough on the RG and is applicable in bridge and router modes.
When disabled the RG will function without any IPv6 passthrough
When IPv6 passthrough is… | scalar | Enumeration | .1.3.6.1.4.1.1429.79.2.1.1.9 |