saRgDeviceRemoteWebAccessPort

SA-RG-MIB · .1.3.6.1.4.1.1429.79.2.1.1.4
MIB view Table view

Object

scalar r/w INET-ADDRESS-MIBInetPortNumber 
Defines what port to use for the WAN IP address of the gateway
to be able to access RG web pages.
This value is to be stored in non-vol and will persist across reboots.
Only a factory reset would clear it

Context

MIB
SA-RG-MIB
OID
.1.3.6.1.4.1.1429.79.2.1.1.4
Type
scalar
Access
readwrite
Status
current
Parent
saRgDeviceBase
Siblings
7

Syntax

INET-ADDRESS-MIBInetPortNumber
Source
INET-ADDRESS-MIBInetPortNumber
Base type
Unsigned32

Values & Constraints

Type Constraints
range: 0..65535

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
saRgDeviceMode
Defines the mode of operation for the device. This parameter is stored in non-vol and is multiSsid(1) by default. Setting this object via SNMP will cause the unit to reboot. …
scalarEnumeration.1.3.6.1.4.1.1429.79.2.1.1.1
saRgDeviceFactoryReset
Set routerAndWifi(1) to restore default settings of both the router and wifi. Set routerOnly(2) to restore default settings of the router. Set wifi(3) to restore default settings …
scalarEnumeration.1.3.6.1.4.1.1429.79.2.1.1.1002
saRgDeviceResetDefaultEnable
This object controls the reset to factory default functionality of the gateway. This prevents the local user from using the reset switch to gain access to the setup pages using th…
scalarSNMPv2-TCTruthValue.1.3.6.1.4.1.1429.79.2.1.1.2
saRgDeviceLanLanIsolation
This MIB is only available in D3.0 products. This MIB does not take effect if the modem is in VLAN mode i.e if saRgIpMgmtLanMode.32=vlan(5). Lan-Lan Isolation allows you block IP …
scalarEnumeration.1.3.6.1.4.1.1429.79.2.1.1.6
saRgDeviceLanWlanIsolation
This MIB is only available in D3.0 products. This MIB does not take effect if the modem is in VLAN mode i.e if saRgIpMgmtLanMode.32=vlan(5). Lan-Wlan Isolation allows you block IP…
scalarEnumeration.1.3.6.1.4.1.1429.79.2.1.1.7
saRgDeviceIpv6Trans
This MIB will control which IPv6 transition technology is enabled on the device. After setting this MIB to disable in the config file, IPv4 traffic will pass normally thro…
scalarEnumeration.1.3.6.1.4.1.1429.79.2.1.1.8
saRgDeviceIpv6Passthrough
This MIB controls IPv6 passthrough on the RG and is applicable in bridge and router modes. When disabled the RG will function without any IPv6 passthrough When IPv6 passthrough is…
scalarEnumeration.1.3.6.1.4.1.1429.79.2.1.1.9