rcIsisLogicalInterfaceIpsecResponderOnly

RC-ISIS-MIB · .1.3.6.1.4.1.2272.1.63.26.1.21
MIB view Table view

Object

column r/w SNMPv2-TCTruthValue 
Indicates if IPSec session of this logical interface should be in responder only
mode. When this config is made true it will not initiate the IPSec connection but
only respond to the incoming connection.
By default both the sides of IPSec connection will be initiators. When there is
NAT in between the IPSec connection, configure this to true on IPSec responder
logical interface.
Note: IPSec responder-only is set to true and If IPSec is enabled
on Initiator side, ipsec needs to be disabled and enabled on
intiator side to re-initiate the connection

Context

MIB
RC-ISIS-MIB
OID
.1.3.6.1.4.1.2272.1.63.26.1.21
Type
column
Access
readwrite
Status
current
Parent
rcIsisLogicalInterfaceEntry
Table
rcIsisLogicalInterfaceTable
Siblings
23

Syntax

SNMPv2-TCTruthValue
Source
SNMPv2-TCTruthValue
Base type
Enumeration

Values & Constraints

Type Values
1true
2false

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
rcIsisLogicalInterfaceId
An index used to uniquely identify this logical interface.
columnInteger32.1.3.6.1.4.1.2272.1.63.26.1.1
rcIsisLogicalInterfaceCircIndex
An index used to indentify ISIS circuit created under the logical interface
columnDIFFSERV-MIBIndexInteger.1.3.6.1.4.1.2272.1.63.26.1.10
rcIsisLogicalInterfaceNextHopIfIndex
Next hop destination ifindex to reach the logical tunnel dest-ip
columnIF-MIBInterfaceIndex.1.3.6.1.4.1.2272.1.63.26.1.11
rcIsisLogicalInterfaceNextHopVid
Next hop vlan id to reach logical tunnel dest-ip It is deprecated by rcIsisLogicalInterfaceNextHopDestIfIndex
columnInteger32.1.3.6.1.4.1.2272.1.63.26.1.12
rcIsisLogicalInterfaceNextHopVrf
Next hop vrf name to reach logical tunnel dest-ip It is deprecated by rcIsisLogicalInterfaceNextHopDestVid
columnOctetString.1.3.6.1.4.1.2272.1.63.26.1.13
rcIsisLogicalInterfaceIpsecEnable
Indicate if IPSec is enabled on logical interface
columnSNMPv2-TCTruthValue.1.3.6.1.4.1.2272.1.63.26.1.14
rcIsisLogicalInterfaceAuthenticationKey
Authentication key for IPSec on logical interface
columnOctetString.1.3.6.1.4.1.2272.1.63.26.1.15
rcIsisLogicalInterfaceShapingRate
Egress shaping rate value on ISIS logical interface
columnInteger32.1.3.6.1.4.1.2272.1.63.26.1.16
rcIsisLogicalInterfaceMtu
The value specifies MTU of logical interface tunnel
columnInteger32.1.3.6.1.4.1.2272.1.63.26.1.17
rcIsisLogicalInterfaceEncryptionKeyLength
The length of key used for encryption in IPSec Tunnel
columnEnumeration.1.3.6.1.4.1.2272.1.63.26.1.18
rcIsisLogicalInterfaceIpsecTunnelDestAddress
The IPSec Destination IP address
columnSNMPv2-SMIIpAddress.1.3.6.1.4.1.2272.1.63.26.1.19
rcIsisLogicalInterfaceIfIndex
The ISIS logical ifIndex
columnIF-MIBInterfaceIndex.1.3.6.1.4.1.2272.1.63.26.1.2
rcIsisLogicalInterfaceBfdEnable
Used to enable/disable BFD on ISIS logical interface.
columnRAPID-CITYEnableValue.1.3.6.1.4.1.2272.1.63.26.1.20
rcIsisLogicalInterfaceIpsecRemoteNatIPAddr
IPSec remote NAT IP address. This needs to be configured in IPSec initiator logical interface when there is NAT on both side the of IPSec tunnel
columnSNMPv2-SMIIpAddress.1.3.6.1.4.1.2272.1.63.26.1.22
rcIsisLogicalInterfaceIpsecAuthMethod
Method of authentication to use when validating the identity of remote IPSEC peer. - preSharedKey - pre shared keys - rsaSignedDigitalCert - RSA signed digital certificates
columnEnumeration.1.3.6.1.4.1.2272.1.63.26.1.23
rcIsisLogicalInterfaceIpsecCompression
Indicate if IPSec compression is enabled on logical interface. This object is applicable only for ExtremeAccess platforms XA1440 and XA1480.
columnSNMPv2-TCTruthValue.1.3.6.1.4.1.2272.1.63.26.1.24
rcIsisLogicalInterfaceType
Indicates the entry is for Layer2 or Layer3
columnEnumeration.1.3.6.1.4.1.2272.1.63.26.1.3
rcIsisLogicalInterfaceDestIPAddr
The logical interface Destination IP address
columnSNMPv2-SMIIpAddress.1.3.6.1.4.1.2272.1.63.26.1.4
rcIsisLogicalInterfaceDestIfIndex
The value of ifIndex for the interface to which this logical interface corresponds. It can be port/mlt ifindex.
columnIF-MIBInterfaceIndex.1.3.6.1.4.1.2272.1.63.26.1.5
rcIsisLogicalInterfaceVids
This bitfield is used to identify which VLANs this logical interface is associated with. Each VLAN ID is stored as a bit. The most-significant (left-most) bit represents Vlan I…
columnOctetString.1.3.6.1.4.1.2272.1.63.26.1.6
rcIsisLogicalInterfacePrimaryVid
Primary tunnel vlan associated with L2Core ISIS logical interface
columnInteger32.1.3.6.1.4.1.2272.1.63.26.1.7
rcIsisLogicalInterfaceName
An administratively-assigned name for this Logical interface.
columnOctetString.1.3.6.1.4.1.2272.1.63.26.1.8
rcIsisLogicalInterfaceRowStatus
Used to create/delete logical interface
columnSNMPv2-TCRowStatus.1.3.6.1.4.1.2272.1.63.26.1.9