rcIsisLogicalInterfaceCircIndex
RC-ISIS-MIB ·
.1.3.6.1.4.1.2272.1.63.26.1.10
Object
column
DIFFSERV-MIBIndexInteger
An index used to indentify ISIS circuit created under the logical interface
Context
- MIB
- RC-ISIS-MIB
- OID
.1.3.6.1.4.1.2272.1.63.26.1.10- Type
- column
- Access
- readonly
- Status
- current
- Parent
- rcIsisLogicalInterfaceEntry
- Table
- rcIsisLogicalInterfaceTable
- Siblings
- 23
Syntax
DIFFSERV-MIBIndexInteger
- Source
- DIFFSERV-MIBIndexInteger
- Base type
Unsigned32
Values & Constraints
Type Constraints
range: 1..4294967295
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| rcIsisLogicalInterfaceId An index used to uniquely identify this logical interface. | column | Integer32 | .1.3.6.1.4.1.2272.1.63.26.1.1 |
| rcIsisLogicalInterfaceNextHopIfIndex Next hop destination ifindex to reach the
logical tunnel dest-ip | column | IF-MIBInterfaceIndex | .1.3.6.1.4.1.2272.1.63.26.1.11 |
| rcIsisLogicalInterfaceNextHopVid Next hop vlan id to reach logical
tunnel dest-ip
It is deprecated by rcIsisLogicalInterfaceNextHopDestIfIndex | column | Integer32 | .1.3.6.1.4.1.2272.1.63.26.1.12 |
| rcIsisLogicalInterfaceNextHopVrf Next hop vrf name to reach
logical tunnel dest-ip
It is deprecated by rcIsisLogicalInterfaceNextHopDestVid | column | OctetString | .1.3.6.1.4.1.2272.1.63.26.1.13 |
| rcIsisLogicalInterfaceIpsecEnable Indicate if IPSec is enabled on logical interface | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.2272.1.63.26.1.14 |
| rcIsisLogicalInterfaceAuthenticationKey Authentication key for IPSec on logical interface | column | OctetString | .1.3.6.1.4.1.2272.1.63.26.1.15 |
| rcIsisLogicalInterfaceShapingRate Egress shaping rate value on ISIS logical interface | column | Integer32 | .1.3.6.1.4.1.2272.1.63.26.1.16 |
| rcIsisLogicalInterfaceMtu The value specifies MTU of logical interface tunnel | column | Integer32 | .1.3.6.1.4.1.2272.1.63.26.1.17 |
| rcIsisLogicalInterfaceEncryptionKeyLength The length of key used for encryption in IPSec Tunnel | column | Enumeration | .1.3.6.1.4.1.2272.1.63.26.1.18 |
| rcIsisLogicalInterfaceIpsecTunnelDestAddress The IPSec Destination IP address | column | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.2272.1.63.26.1.19 |
| rcIsisLogicalInterfaceIfIndex The ISIS logical ifIndex | column | IF-MIBInterfaceIndex | .1.3.6.1.4.1.2272.1.63.26.1.2 |
| rcIsisLogicalInterfaceBfdEnable Used to enable/disable BFD on ISIS logical interface. | column | RAPID-CITYEnableValue | .1.3.6.1.4.1.2272.1.63.26.1.20 |
| rcIsisLogicalInterfaceIpsecResponderOnly Indicates if IPSec session of this logical interface should be in responder only
mode. When this config is made true it will not initiate the IPSec connection but
only respond to … | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.2272.1.63.26.1.21 |
| rcIsisLogicalInterfaceIpsecRemoteNatIPAddr IPSec remote NAT IP address.
This needs to be configured in IPSec initiator logical interface
when there is NAT on both side the of IPSec tunnel | column | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.2272.1.63.26.1.22 |
| rcIsisLogicalInterfaceIpsecAuthMethod Method of authentication to use when validating
the identity of remote IPSEC peer.
- preSharedKey - pre shared keys
- rsaSignedDigitalCert - RSA signed digital certificates | column | Enumeration | .1.3.6.1.4.1.2272.1.63.26.1.23 |
| rcIsisLogicalInterfaceIpsecCompression Indicate if IPSec compression is enabled on logical interface.
This object is applicable only for ExtremeAccess platforms XA1440 and XA1480. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.2272.1.63.26.1.24 |
| rcIsisLogicalInterfaceType Indicates the entry is for Layer2 or Layer3 | column | Enumeration | .1.3.6.1.4.1.2272.1.63.26.1.3 |
| rcIsisLogicalInterfaceDestIPAddr The logical interface Destination IP address | column | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.2272.1.63.26.1.4 |
| rcIsisLogicalInterfaceDestIfIndex The value of ifIndex for the interface to which this
logical interface corresponds. It can be port/mlt ifindex. | column | IF-MIBInterfaceIndex | .1.3.6.1.4.1.2272.1.63.26.1.5 |
| rcIsisLogicalInterfaceVids This bitfield is used to identify which VLANs this
logical interface is associated with. Each VLAN ID
is stored as a bit. The most-significant (left-most)
bit represents Vlan I… | column | OctetString | .1.3.6.1.4.1.2272.1.63.26.1.6 |
| rcIsisLogicalInterfacePrimaryVid Primary tunnel vlan associated with L2Core ISIS logical interface | column | Integer32 | .1.3.6.1.4.1.2272.1.63.26.1.7 |
| rcIsisLogicalInterfaceName An administratively-assigned name for this Logical interface. | column | OctetString | .1.3.6.1.4.1.2272.1.63.26.1.8 |
| rcIsisLogicalInterfaceRowStatus Used to create/delete logical interface | column | SNMPv2-TCRowStatus | .1.3.6.1.4.1.2272.1.63.26.1.9 |