systemNtpUpdateInterval
RAD-MIB ·
.1.3.6.1.4.1.164.6.2.14.4.5
Object
This variable represents the NTP Update Interval, measured in seconds. It means, minimum time between two consecutive NTP requests.
Syntax
SNMPv2-SMIUnsigned32
- Source
- SNMPv2-SMIUnsigned32
- Base type
Unsigned32
Values & Constraints
Enumerated Values
2 | off |
3 | on |
Type Constraints
range: 0..4294967295
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| systemNtpMode This variable represents the NTP Mode. | scalar | Enumeration | .1.3.6.1.4.1.164.6.2.14.4.1 |
| systemNtpCurrentSource IP Address (ipv4) of the Server (or Local HW) providing the
current Date and Time of the device.
127.0.0.1 = local HW clock is used.
0.0.0.0 = no clock is available. | scalar | INET-ADDRESS-MIBInetAddress | .1.3.6.1.4.1.164.6.2.14.4.10 |
| sntpServerTable This table contains parameters for each NTP Server.
Entries in the table can be dynamically created.
The entries created by user via sntpServerRowStatus, can also be
changed… | table | - | .1.3.6.1.4.1.164.6.2.14.4.11 |
| systemNtpGmt This variable represents the NTP GMT (Greenwich Mean Time),
Possible values range is -12..12.
For new devices/versions this variable will be in minutes. | scalar | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.164.6.2.14.4.2 |
| systemNtpServerAddressType This variable represents the NTP Server Address Type. | scalar | INET-ADDRESS-MIBInetAddressType | .1.3.6.1.4.1.164.6.2.14.4.3 |
| systemNtpServerAddress This variable represents the NTP Server Address. | scalar | INET-ADDRESS-MIBInetAddress | .1.3.6.1.4.1.164.6.2.14.4.4 |
| systemNtpCmd This variable represents NTP possible commands.
After the Agent accepts a command, it will automatically change
the value to off(2). | scalar | Enumeration | .1.3.6.1.4.1.164.6.2.14.4.6 |
| systemNtpTimeSinceLastPoll Time in seconds, that passed from last polling of the configured
SNTP servers. 0=Not Applicable (when this time is not known). | scalar | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.164.6.2.14.4.7 |
| systemNtpModeBITS If Bit 0 (broadcastClient) is '1', Broadcast Mode is enabled,
meaning that the device listens to the NTP broadcast messages
and learns timestamps from them.
If disabled (Bit 0 =… | scalar | Bits | .1.3.6.1.4.1.164.6.2.14.4.8 |
| systemNtpCurrentSourceType Type IP address of the NTP server currently providing system TOD. | scalar | INET-ADDRESS-MIBInetAddressType | .1.3.6.1.4.1.164.6.2.14.4.9 |