xATSSwitchSettingsAllowClosedTransfer

PowerNet-MIB · .1.3.6.1.4.1.318.1.1.17.3.2.6
MIB view Table view

Object

scalar mandatory r/w Enumeration 
This setting enables seamless (closed) transfers between sources.
When possible, both source 1 and source 2 are closed to the output
for a brief time. If closed transfer is not possible within the amount
of time specified by the xATSSwitchSettingsMaxSyncTime OID,
an open transfer will be executed.

Context

MIB
PowerNet-MIB
OID
.1.3.6.1.4.1.318.1.1.17.3.2.6
Type
scalar
Access
readwrite
Status
mandatory
Parent
xATSSwitchSettings
Siblings
9

Syntax

Enumeration

Values & Constraints

Enumerated Values
1yes
2no
3unknown

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
xATSSwitchSettingsLowVoltageTransferPoint mandatory
The lowest acceptable voltage condition at source 1. When any phase of source 1 is lower than this voltage, source quality is considered bad and the generator run signal is assert…
scalarInteger32.1.3.6.1.4.1.318.1.1.17.3.2.1
xATSSwitchSettingsSetToFactoryDefaults mandatory
Sets all transfer switch settings to factory default values.
scalarEnumeration.1.3.6.1.4.1.318.1.1.17.3.2.10
xATSSwitchSettingsHighVoltageTransferPoint mandatory
The highest acceptable voltage condition at source 1. When any phase of source 1 is greater than this voltage, source quality is considered bad and the generator run signal is ass…
scalarInteger32.1.3.6.1.4.1.318.1.1.17.3.2.2
xATSSwitchSettingsMaxFrequencyDeviation mandatory
The maximum acceptable frequency deviation condition from nominal at source 1. When source 1 frequency is outside the specified range, source quality is considered bad and the gen…
scalarInteger32.1.3.6.1.4.1.318.1.1.17.3.2.3
xATSSwitchSettingsMinPhaseBalance mandatory
The minimum required phase balance at source 1. When the percentage difference between the minimum and maximum phase voltage measurements at source 1 is greater than this value, s…
scalarInteger32.1.3.6.1.4.1.318.1.1.17.3.2.4
xATSSwitchSettingsNominalRotation mandatory
The nominal phase rotation (or phase sequence) required by the load. For certain types of equipment, such as rotating machinery, phase rotation is critical for proper operation as…
scalarEnumeration.1.3.6.1.4.1.318.1.1.17.3.2.5
xATSSwitchSettingsMaxSyncTime mandatory
When attempting/seeking to perform a closed transfer, this setting defines the maximum time allowed before the transfer switch will give up and perform an open transfer. Specified…
scalarInteger32.1.3.6.1.4.1.318.1.1.17.3.2.7
xATSSwitchSettingsNeutralTransferTime mandatory
This setting defines how long both source 1 and source 2 will be disconnected from the output, during an open transfer. Specified in seconds. -1 if not available.
scalarInteger32.1.3.6.1.4.1.318.1.1.17.3.2.8
xATSSwitchSettingsClearLatchedAlarms mandatory
Clears any latched alarm conditions.
scalarEnumeration.1.3.6.1.4.1.318.1.1.17.3.2.9