xATSGeneratorSettingsCrankRestTime

PowerNet-MIB · .1.3.6.1.4.1.318.1.1.18.1.5.7
MIB view Table view

Object

scalar mandatory Integer32 
The pause duration, in seconds, following an unsuccessful attempt to start the generator.
Applicable when the xATSGeneratorSettingsCrankCycleEnable OID is enabled.
-1 if not available.

Context

MIB
PowerNet-MIB
OID
.1.3.6.1.4.1.318.1.1.18.1.5.7
Type
scalar
Access
readonly
Status
mandatory
Parent
xATSGeneratorSettings
Siblings
8

Syntax

Integer32
Source
COPS-PR-SPPIInteger32
Base type
Integer32

Values & Constraints

Type Constraints
range: -2147483648..2147483647

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
xATSGeneratorSettingsVoltageAdjust mandatory
The voltage adjust of the generator. Specified in volts line-to-line, or -1 if not available.
scalarInteger32.1.3.6.1.4.1.318.1.1.18.1.5.1
xATSGeneratorSettingsFrequencyAdjust mandatory
The frequency adjust of the generator. Specified in tenths of Hertz.
scalarInteger32.1.3.6.1.4.1.318.1.1.18.1.5.2
xATSGeneratorSettingsStartDelay mandatory
The delay, in seconds, after the remote run signal is activated before the generator's engine will be cranked to start, or -1 if not available.
scalarInteger32.1.3.6.1.4.1.318.1.1.18.1.5.3
xATSGeneratorSettingsStopDelay mandatory
The delay, in seconds, before the generator will stop after the remote run signal is deactivated, or -1 if not available.
scalarInteger32.1.3.6.1.4.1.318.1.1.18.1.5.4
xATSGeneratorSettingsCrankCycleEnable mandatory
When Crank Cycle is enabled, the engine will be cranked up to the time specified by the xATSGeneratorSettingsCrankTime OID. If the generator's engine does not start, there will be…
scalarEnumeration.1.3.6.1.4.1.318.1.1.18.1.5.5
xATSGeneratorSettingsCrankTime mandatory
The duration of engine cranking, in seconds, when starting the generator. Applicable when the xATSGeneratorSettingsCrankCycleEnable OID is enabled. -1 if not available.
scalarInteger32.1.3.6.1.4.1.318.1.1.18.1.5.6
xATSGeneratorSettingsNumberCrank mandatory
The number of failed crank attempts before giving up on starting the generator. Applicable when the xATSGeneratorSettingsCrankCycleEnable OID is enabled. -1 if not available.
scalarInteger32.1.3.6.1.4.1.318.1.1.18.1.5.8
xATSGeneratorSettingsMetricUnit mandatory
Specifies the use of metric units in generator related OIDs, as well as on all other interfaces including the generator's local interface.
scalarEnumeration.1.3.6.1.4.1.318.1.1.18.1.5.9