xATSGeneratorSettingsCrankCycleEnable

PowerNet-MIB · .1.3.6.1.4.1.318.1.1.18.1.5.5
MIB view Table view

Object

scalar mandatory Enumeration 
When Crank Cycle is enabled, the engine will be cranked up to the time
specified by the xATSGeneratorSettingsCrankTime OID.
If the generator's engine does not start, there will be a pause as
specified by the xATSGeneratorSettingsCrankRestTime OID before the
engine will be cranked again. This cycle is repeated as specified by
the xATSGeneratorSettingsNumberCrank OID.
When crank cycle is disabled, the generator's engine will be
cranked continuously until it starts.

Context

MIB
PowerNet-MIB
OID
.1.3.6.1.4.1.318.1.1.18.1.5.5
Type
scalar
Access
readonly
Status
mandatory
Parent
xATSGeneratorSettings
Siblings
8

Syntax

Enumeration

Values & Constraints

Enumerated Values
1disabled
2enabled
3unknown

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
xATSGeneratorSettingsVoltageAdjust mandatory
The voltage adjust of the generator. Specified in volts line-to-line, or -1 if not available.
scalarInteger32.1.3.6.1.4.1.318.1.1.18.1.5.1
xATSGeneratorSettingsFrequencyAdjust mandatory
The frequency adjust of the generator. Specified in tenths of Hertz.
scalarInteger32.1.3.6.1.4.1.318.1.1.18.1.5.2
xATSGeneratorSettingsStartDelay mandatory
The delay, in seconds, after the remote run signal is activated before the generator's engine will be cranked to start, or -1 if not available.
scalarInteger32.1.3.6.1.4.1.318.1.1.18.1.5.3
xATSGeneratorSettingsStopDelay mandatory
The delay, in seconds, before the generator will stop after the remote run signal is deactivated, or -1 if not available.
scalarInteger32.1.3.6.1.4.1.318.1.1.18.1.5.4
xATSGeneratorSettingsCrankTime mandatory
The duration of engine cranking, in seconds, when starting the generator. Applicable when the xATSGeneratorSettingsCrankCycleEnable OID is enabled. -1 if not available.
scalarInteger32.1.3.6.1.4.1.318.1.1.18.1.5.6
xATSGeneratorSettingsCrankRestTime mandatory
The pause duration, in seconds, following an unsuccessful attempt to start the generator. Applicable when the xATSGeneratorSettingsCrankCycleEnable OID is enabled. -1 if not avail…
scalarInteger32.1.3.6.1.4.1.318.1.1.18.1.5.7
xATSGeneratorSettingsNumberCrank mandatory
The number of failed crank attempts before giving up on starting the generator. Applicable when the xATSGeneratorSettingsCrankCycleEnable OID is enabled. -1 if not available.
scalarInteger32.1.3.6.1.4.1.318.1.1.18.1.5.8
xATSGeneratorSettingsMetricUnit mandatory
Specifies the use of metric units in generator related OIDs, as well as on all other interfaces including the generator's local interface.
scalarEnumeration.1.3.6.1.4.1.318.1.1.18.1.5.9