dm3ConfigLVDResetThresh
PowerNet-MIB ·
.1.3.6.1.4.1.318.1.1.7.2.2.2.1.5
Object
column
mandatory
r/w
Integer32
LVD Reset threshold. If voltage exceeds threshold, the LVD will reset.
Values are represented in thousandths of Volts (mV).
Attempts to set the value above or below the acceptable range of the powerplant
will cause the value to be set at the high or low point of the range respectively.
Context
- MIB
- PowerNet-MIB
- OID
.1.3.6.1.4.1.318.1.1.7.2.2.2.1.5- Type
- column
- Access
- readwrite
- Status
- mandatory
- Parent
- dm3ConfigLVDEntry
- Table
- dm3ConfigLVDTable
- Siblings
- 6
Syntax
Integer32
- Source
- COPS-PR-SPPIInteger32
- Base type
Integer32
Values & Constraints
Type Constraints
range: -2147483648..2147483647
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| dm3ConfigLVDIndex mandatory The index to the DC powerplant LVD. | column | Integer32 | .1.3.6.1.4.1.318.1.1.7.2.2.2.1.1 |
| dm3ConfigLVDName mandatory The name of the LVD. The maximum value is 16 characters. | column | RFC1213-MIBDisplayString | .1.3.6.1.4.1.318.1.1.7.2.2.2.1.2 |
| dm3ConfigLVDEnable mandatory This OID is used to control and indicate if the LVD is on or off.
Setting this OID to enabledYes (1) will enable (turn on) the LVD.
Setting this OID to enabledNo (2) will disable … | column | Enumeration | .1.3.6.1.4.1.318.1.1.7.2.2.2.1.3 |
| dm3ConfigLVDTripThresh mandatory LVD Trip threshold. If voltage exceeds threshold, the LVD will trip.
Values are represented in thousandths of Volts (mV).
Attempts to set the value above or below … | column | Integer32 | .1.3.6.1.4.1.318.1.1.7.2.2.2.1.4 |
| dm3ConfigLVDOpenAlarm mandatory For the LVD Open Alarm;
Setting this OID to alarmIgnore (1) results in the alarm condition being ignored.
Setting this OID to alarmRelay1 (2) causes relay 1 to be activated for an… | column | Enumeration | .1.3.6.1.4.1.318.1.1.7.2.2.2.1.6 |
| dm3ConfigLVDHWAlarm mandatory For the LVD Hardware Alarm;
Setting this OID to alarmIgnore (1) results in the alarm condition being ignored.
Setting this OID to alarmRelay1 (2) causes relay 1 to be activated fo… | column | Enumeration | .1.3.6.1.4.1.318.1.1.7.2.2.2.1.7 |