ostFpgaUpdTable

This table enables the chassis master's management entity to update the FPGA firmware
of a module via a file residing on a module that was previously loaded by FTP.
          
Steps to use entries in this table:
          
1) Wait for ostFpgaUpdReady value to be true. To do this do this sequence:
   a. an SNMP GET for both SnmpSetSerialNo and ostFpgaUpdReady objects (in same SNMP PDU).
   b. Check if value for ostFpgaUpdReady is true.
      - if not, wait x seconds, go to step a above.
      - if yes, save the value of SnmpSetSerialNo and go to step 2) below
          
2) Change ostFpgaUpdReady value from true to false to ensure no other management entity
   will use the service. In order to not disturb a possible other NMS do this by sending
   an SNMP SET for both SnmpSetSerialNo and ostFgaUpdgReady objects (in same SNMP PDU, and
   make sure SNmpSetSerialNo is the first varBind).
          
   For the SnmpSetSerialNo varBind, use the value that you obtained in step 1)a. This ensures
   that two cooperating NMSes will not interfere with each other.
          
3) Set ostFpgaUpdAction to write(1) value to initiate command operation.
          
4) Check the value of ostFpgaUpdLastStatus to find out if the operation was successfully completed.
          
5) Change the ostFpgaUpdReady value back to true to allow other management entities to use the table.

MIB

OMNITRON-EXT-MIB

OID

.1.3.6.1.4.1.7342.7.1.13.1

Type

table

Status

current

Parent

ostFpgaUpd

Children

1