upsCtlSleepTime
NEXT-UPS-MIB ·
.0.1.1.8.2
Object
scalar
r/w
minutes Integer32
The time in minutes for the UPS to go to sleep when
instructed. When in sleep mode, the UPS will not provide
output power regardless of the input line state. Once the
specified time has elapsed, output power will be restored.
This is a configuration setting. The UPS will not go to
sleep until told to do so by the manager from a management
station.
Any input value is allowed, however the UPS only recognizes
0 - 9999 minutes in one minute increments.
If the provided value is higher than the highest acceptable
value, the highest acceptable value is used.
Context
- MIB
- NEXT-UPS-MIB
- OID
.0.1.1.8.2- Type
- scalar
- Access
- readwrite
- Status
- current
- Units
- minutes
- Parent
- upsControl
- Siblings
- 9
Syntax
minutes Integer32
Values & Constraints
Object Constraints
range: -1-2147483648
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| upsCtlShutdownDelay The delay in seconds the UPS remains on after being told
to turn off. if value=-2 cancel shutdown, if value=-1 donothing,
value=0 shutdown ups immediately | scalar | seconds Integer32 | .0.1.1.8.1 |
| upsCtlResetConfigure reset all configure para to default. | scalar | Enumeration | .0.1.1.8.10 |
| upsCtlStartupAfterDelay Setting this object will start the output after the
indicated number of seconds, including starting the
UPS, if necessary. -1 mean not startup.
must set upsCtlStartupAfterDela… | scalar | seconds Integer32 | .0.1.1.8.3 |
| upsCtlbuzzer Setting this object to 'on' or 'off' to enable or disable buzzer | scalar | Enumeration | .0.1.1.8.4 |
| upsCtlRemoteControlUPS Setting this object to turn 'on' or 'off' UPS | scalar | Enumeration | .0.1.1.8.5 |
| upsCtloutletPoweron Setting this object to 1 means 1st outlet,2 means 2nd outlet , immediately process | scalar | Integer32 | .0.1.1.8.6 |
| upsCtloutletPoweroff Setting this object to 1 means 1st outlet,
2 means 2nd outlet , immediately process | scalar | Integer32 | .0.1.1.8.7 |
| upsCtlOutlet1Powerofftime setting this object to -1 means this control not effect,
0 means immediately process,
>0 means wait times unit is minutes
use in battery mode | scalar | Integer32 | .0.1.1.8.8 |
| upsCtlOutlet2Powerofftime setting this object to -1 means this control not effect,
0 means immediately process ,
>0 means wait times unit is minutes .use in battery mode | scalar | Integer32 | .0.1.1.8.9 |