vasPulSnkFailure
NETI-VAS-MIB ·
.1.3.6.1.4.1.2928.2.5.4.6.1.7
Object
column
SNMP-FRAMEWORK-MIBSnmpAdminString
A string describing the configuration or error status of the object. The string is the empty string if the configuration is correct and no error is present, otherwise it contains a message describing the error.
Context
- MIB
- NETI-VAS-MIB
- OID
.1.3.6.1.4.1.2928.2.5.4.6.1.7- Type
- column
- Access
- readonly
- Status
- current
- Parent
- vasPulSnkEntry
- Table
- vasPulSnkTable
- Siblings
- 25
Syntax
SNMP-FRAMEWORK-MIBSnmpAdminString
- Source
- SNMP-FRAMEWORK-MIBSnmpAdminString
- Base type
OctetString
Values & Constraints
Type Constraints
range: 0..255
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| vasPulSnkIndex An index that uniquely identifies the pull sink in the
table. | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2928.2.5.4.6.1.1 |
| vasPulSnkResetStatistics Resets all statistics counters for the object. (Not yet
implemented). | column | VasResetStatistics | .1.3.6.1.4.1.2928.2.5.4.6.1.10 |
| vasPulSnkStatsTrsp Index for an entry in statistics vasTrspStatisticsTable table
for this object. | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2928.2.5.4.6.1.11 |
| vasPulSnkStatsTr101 Index for an entry in ETSI TR 101 290 statistics table for
this object. (The table is not yet defined). | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2928.2.5.4.6.1.12 |
| vasPulSnkEnableTr101 Enables or disables ETSI TR 101 290 statistics collection. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.2928.2.5.4.6.1.13 |
| vasPulSnkRemoteInetType Format of vasPulSrcRemoteInetAddress. | column | INET-ADDRESS-MIBInetAddressType | .1.3.6.1.4.1.2928.2.5.4.6.1.14 |
| vasPulSnkRemoteInetAddress The IP address of the remote host from where the transport
stream is received. The value is empty and
vasPulSnkRemoteInetType is `unknown' when a stream
is not received. | column | INET-ADDRESS-MIBInetAddress | .1.3.6.1.4.1.2928.2.5.4.6.1.15 |
| vasPulSnkStreamId Specifies the stream ID of the stream on the remote host that
shall be received. The stream ID is a string that identifies
the transport stream in all nodes where the stream exis… | column | SNMP-FRAMEWORK-MIBSnmpAdminString | .1.3.6.1.4.1.2928.2.5.4.6.1.16 |
| vasPulSnkPassword The password to use for the received transport stream. The
password must match the vasPulSrcPassword set on the source
at the remote host. | column | SNMP-FRAMEWORK-MIBSnmpAdminString | .1.3.6.1.4.1.2928.2.5.4.6.1.17 |
| vasPulSnkRemoteHostType Format of vasPulSnkRemoteHostAddress. Supported values are
`unknown', `ipv4', and `dns'. | column | INET-ADDRESS-MIBInetAddressType | .1.3.6.1.4.1.2928.2.5.4.6.1.18 |
| vasPulSnkRemoteHostAddress The IP address or DNS hostname of the remote host from where
the transport stream shall be pulled. This address is the
first host that will be attempted when a transport stream i… | column | INET-ADDRESS-MIBInetAddress | .1.3.6.1.4.1.2928.2.5.4.6.1.19 |
| vasPulSnkRowStatus See SNMPv2-TC. Use vasPulSnkAdminStatus to activate and
de-activate a Pull sink. The following values are supported:
active(1). The object always reads active.
… | column | SNMPv2-TCRowStatus | .1.3.6.1.4.1.2928.2.5.4.6.1.2 |
| vasPulSnkRemoteHostType2 Format of vasPulSnkRemoteHostAddress2. Supported values are
`unknown', `ipv4', and `dns'. | column | INET-ADDRESS-MIBInetAddressType | .1.3.6.1.4.1.2928.2.5.4.6.1.20 |
| vasPulSnkRemoteHostAddress2 The second IP address or DNS hostname of the remote host from
where the transport stream shall be pulled. When using two
addresses, then the transport is setup with two alternati… | column | INET-ADDRESS-MIBInetAddress | .1.3.6.1.4.1.2928.2.5.4.6.1.21 |
| vasPulSnkRemotePort The UDP port on the remote host that the remote host is
listening for connection attempts. See vaStreamPort. | column | INET-ADDRESS-MIBInetPortNumber | .1.3.6.1.4.1.2928.2.5.4.6.1.22 |
| vasPulSnkRetransmitBuffer The size of the retransmission buffer in milliseconds (ms).
The retransmission buffer setting adds bandwidth on the
sender side to compensate for packet loss. The setting will
af… | column | Unsigned32 | .1.3.6.1.4.1.2928.2.5.4.6.1.23 |
| vasPulSnkFecMaxOverhead The Forward Error Correction (FEC) overhead in percent (%) of
the original stream bit rate. FEC increases the streams
tolerance of burst errors and corrects for single errors, as… | column | Unsigned32 | .1.3.6.1.4.1.2928.2.5.4.6.1.24 |
| vasPulSnkFecOptimize Whether to automatically optimize Forward Error Correction
(FEC). Optimization will favor the video stream and visually
important frames, I and IDR-frames, over others, such as
a… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.2928.2.5.4.6.1.25 |
| vasPulSnkFecLatency Forward Error Correction (FEC) block size in milliseconds
(ms). | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2928.2.5.4.6.1.26 |
| vasPulSnkName A textual name of the Pull sink. The name is automatically
assigned by the system. The last part of the name is the
index in this table. | column | SNMP-FRAMEWORK-MIBSnmpAdminString | .1.3.6.1.4.1.2928.2.5.4.6.1.3 |
| vasPulSnkPurpose A text that can describe the purpose of the Pull sink. This
is for administrative use. | column | SNMP-FRAMEWORK-MIBSnmpAdminString | .1.3.6.1.4.1.2928.2.5.4.6.1.4 |
| vasPulSnkAdminStatus The administrative state of the Pull sink. The value
controls the desired state of the Pull sink.
up(1). The Pull sink shall be enabled.
down(2). Th… | column | Enumeration | .1.3.6.1.4.1.2928.2.5.4.6.1.5 |
| vasPulSnkOperStatus The operational state of the Pull sink. The value normally
follow the state of the administrative state.
up(1). The Pull sink is up and operational.
… | column | Enumeration | .1.3.6.1.4.1.2928.2.5.4.6.1.6 |
| vasPulSnkLastChanged The value of sysUpTime when status or configuration of the
objects was last changed. | column | SNMPv2-TCTimeStamp | .1.3.6.1.4.1.2928.2.5.4.6.1.8 |
| vasPulSnkConnectionStatus The status of the stream transport connection. | column | VasConnectionStatus | .1.3.6.1.4.1.2928.2.5.4.6.1.9 |