itsIfPs3MaxExpDifferentialDelay

NETI-ITS-MIB · .1.3.6.1.4.1.2928.6.2.16.1.1.14.1.9
MIB view Table view

Object

column r/w SNMPv2-SMIUnsigned32 
Maximum expected differential delay in milliseconds where 0
(zero) implies largest possible value for channel capacity
and service type.  If measured differential delay is above
this, hitless protected status can not be guaranteed.
              
Maximum assignable value is bit rate and service type
dependent.  The higher the bit rate, the lower the value. For
largest bit rate however, up to 100 ms is guaranteed to work
for all service types.
              
Note also that the larger the value, the greater the latency.
Therefore, for latency sensitive signals as small non-zero
value as possible shall be used.

Context

MIB
NETI-ITS-MIB
OID
.1.3.6.1.4.1.2928.6.2.16.1.1.14.1.9
Type
column
Access
readwrite
Status
current
Parent
itsIfPs3Entry
Table
itsIfPs3Table
Siblings
8

Syntax

SNMPv2-SMIUnsigned32
Source
SNMPv2-SMIUnsigned32
Base type
Unsigned32

Values & Constraints

Type Constraints
range: 0..4294967295

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
itsIfPs3DifferentialDelay
Measured differential delay in microseconds between the two paths. Zero (0) indicates that standby protection is used.
columnSNMPv2-SMIUnsigned32.1.3.6.1.4.1.2928.6.2.16.1.1.14.1.1
itsIfPs3DifferentialDelayValid
Specifies if the value of itsIfPs3DifferentialDelay is valid or not.
columnSNMPv2-TCTruthValue.1.3.6.1.4.1.2928.6.2.16.1.1.14.1.2
itsIfPs3AheadInterface
The index of the sink trail termination point (TTP) that is ahead. Minus one indicates either that information is not available or is invalid.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.2928.6.2.16.1.1.14.1.3
itsIfPs3HitlessProtection
Specifies if hitless protection shall be attempted or not. true(1). Will attempt to reach a hitless protection state. false(2). Will only attempt t…
columnSNMPv2-TCTruthValue.1.3.6.1.4.1.2928.6.2.16.1.1.14.1.4
itsIfPs3ProtectionStatus
The current protection state.
columnItsProtectionStatus.1.3.6.1.4.1.2928.6.2.16.1.1.14.1.5
itsIfPs3ExpectedProtectionStatus
The expected protection state. When the current protection state (see itsIfPs3ProtectionStatus) is lower than the expected protection state, an alarm is raised. The alarm is cle…
columnItsProtectionStatus.1.3.6.1.4.1.2928.6.2.16.1.1.14.1.6
itsIfPs3ForceHit
A write of zero (0) resets the buffers, and will therefore minimize the the latency penalty incurred by the 1+1 buffering.
columnUnsigned32.1.3.6.1.4.1.2928.6.2.16.1.1.14.1.7
itsIfPs3ActiveInterface
The index of the sink trail termination point (TTP) that is is selected as source. Minus one indicates either that information is not available or is invalid.
columnSNMPv2-SMIInteger32.1.3.6.1.4.1.2928.6.2.16.1.1.14.1.8