ethDevIndex
NETI-ETH-MIB ·
.1.3.6.1.4.1.2928.2.2.1.1.1.1.1
Object
column
SNMPv2-SMIUnsigned32
An index in the table. The index is equal to the board position in the node. The index is maintained across reboots of the managed system.
Context
- MIB
- NETI-ETH-MIB
- OID
.1.3.6.1.4.1.2928.2.2.1.1.1.1.1- Type
- column
- Access
- noaccess
- Status
- current
- Parent
- ethDeviceEntry
- Table
- ethDeviceTable
- Siblings
- 29
Syntax
SNMPv2-SMIUnsigned32
- Source
- SNMPv2-SMIUnsigned32
- Base type
Unsigned32
Values & Constraints
Type Constraints
range: 0..4294967295
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| ethDevCapSpanningTree The spanning tree capabilities of forwarding functions on the
device. Describes all supported values of the spanning tree
settings. If spanning tree is not supported, then the v… | column | Bits | .1.3.6.1.4.1.2928.2.2.1.1.1.1.10 |
| ethDevCapVLANMode The VLAN mode capabilities of forwarding functions on the
device. Describes all supported values of the VLAN mode
settings. See ethFwdVLANMode. | column | Bits | .1.3.6.1.4.1.2928.2.2.1.1.1.1.11 |
| ethDevCapAdvertisedDuplex Supported values for the duplex setting of a physical
interface on the device. See dot3AdvertisedDuplex. | column | AdvertisedDuplex | .1.3.6.1.4.1.2928.2.2.1.1.1.1.12 |
| ethDevCapAdvertisedFlowControl Supported values for the flow control setting of a physical
interface on the device. See dot3AdvertisedFlowControl. | column | AdvertisedFlowControl | .1.3.6.1.4.1.2928.2.2.1.1.1.1.13 |
| ethDevCapAcceptableFrameType The frame types capabilities of interfaces on the device.
Describes all supported values of the acceptable frame type
setting. See ethIfAcceptableFrameTypes. | column | Bits | .1.3.6.1.4.1.2928.2.2.1.1.1.1.14 |
| ethDevCapDefaultEthernetPriority The range of allowed values for Ethernet priority of
interfaces on the device. See
ethIfDefaultEthernetPriority. The object consists of two
octets, where the first octet represe… | column | OctetString | .1.3.6.1.4.1.2928.2.2.1.1.1.1.15 |
| ethDevCapLearning The learning capabilities of forwarding functions on the
device. Describes all supported values of the learning
setting. See ethIfLearning. | column | Bits | .1.3.6.1.4.1.2928.2.2.1.1.1.1.16 |
| ethDevCapTransmittedFrameTypeETS The allowed values of the transmitted frame type on an
Ethernet Transport Service Trail Termination Point, ETS TTP.
See ethIfTransmittedFrameType. Note that the interface type
ca… | column | Bits | .1.3.6.1.4.1.2928.2.2.1.1.1.1.17 |
| ethDevCapTransmittedFrameTypeDot3 The allowed values of the transmitted frame type on an dot3
interface. See ethIfTransmittedFrameType. Note that the
interface type can be determined by examine ethIfType. | column | Bits | .1.3.6.1.4.1.2928.2.2.1.1.1.1.18 |
| ethDevCapMaxMaxQueueOctets The maximum value in octets possible to set for the maximum
queue size for queues on the device. See
ethIfQueueMaxOctets. | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2928.2.2.1.1.1.1.19 |
| ethDevRowStatus The following values are supported:
active(1). The object always reads active.
destroy(6). All configurations for the device are deleted.
If the phys… | column | SNMPv2-TCRowStatus | .1.3.6.1.4.1.2928.2.2.1.1.1.1.2 |
| ethDevCapMaxMaxQueueFrames deprecated The maximum value in frames allowed to set for the maximum
queue size for queues on the device. See
ethIfQueueMaxFrames. | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2928.2.2.1.1.1.1.20 |
| ethDevCapMaxTrafficClass The maximum number of traffic classes supported by the
device. Traffic classes are identified by numbers starting
from 0 to, but not including, this value. | column | TrafficClass | .1.3.6.1.4.1.2928.2.2.1.1.1.1.21 |
| ethDevEtsNextIndex The value of the next available index (ethIfIndex) in the
ethEtsTable for this device. | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2928.2.2.1.1.1.1.22 |
| ethDevFwdFuncNextIndex The value of the next available index (ethFwdIndex) in the
ethFwdFuncTable for this device. | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2928.2.2.1.1.1.1.23 |
| ethDevCapPerformanceMonitoring Indicates how the device supports performance monitoring. | column | Enumeration | .1.3.6.1.4.1.2928.2.2.1.1.1.1.24 |
| ethDevCapConfigurableFaultMgmt Indicates how the device supports configurable fault
management. | column | Enumeration | .1.3.6.1.4.1.2928.2.2.1.1.1.1.25 |
| ethDevIfgFirstIndex The value of the first allowed index (ethIfIndex) in the
ethIfgTable for this device. | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2928.2.2.1.1.1.1.26 |
| ethDevIfgNextIndex The value of the next available index (ethIfIndex) in the
ethIfgTable for this device. | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2928.2.2.1.1.1.1.27 |
| ethDevCapDropPrecedenceLevels The number of different drop precedence (DP) levels that
this devices supports. The DP levels are numbered from 0 to
(dropPrecedenceLevels - 1) | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2928.2.2.1.1.1.1.28 |
| ethDevCapDropProbabilityFunctions The drop probability functions supported for this device. | column | Bits | .1.3.6.1.4.1.2928.2.2.1.1.1.1.29 |
| ethDevName The textual name of the device. The value of this object
should be the name of the device as assigned by the local
device and should be suitable for use in commands entered at
th… | column | SNMP-FRAMEWORK-MIBSnmpAdminString | .1.3.6.1.4.1.2928.2.2.1.1.1.1.3 |
| ethDevFailure A string describing the configuration or error status of the
device. The string is the empty string if the configuration
is correct, otherwise a message describing the error. | column | SNMP-FRAMEWORK-MIBSnmpAdminString | .1.3.6.1.4.1.2928.2.2.1.1.1.1.30 |
| ethDevContainerName The name of the container where the physical device is mounted. | column | SNMP-FRAMEWORK-MIBSnmpAdminString | .1.3.6.1.4.1.2928.2.2.1.1.1.1.4 |
| ethDevProductName The name of the product. The value of this object should be
the name of the device as printed on the front panel or
similar. | column | SNMP-FRAMEWORK-MIBSnmpAdminString | .1.3.6.1.4.1.2928.2.2.1.1.1.1.5 |
| ethDevStatus The status of the device, indicating if the board is plugged
in or not.
present(1). The device is present and functional.
absent(2). The device is no… | column | Enumeration | .1.3.6.1.4.1.2928.2.2.1.1.1.1.6 |
| ethDevCapJumboFrames The Jumbo Frames capabilities of forwarding functions on the
device. Describes all supported values of the Jumbo Frames
setting. See ethFwdJumboFrames. | column | Bits | .1.3.6.1.4.1.2928.2.2.1.1.1.1.7 |
| ethDevCapMaxAgingTime The maximum aging time for dynamically learned forwarding
information for forwarding functions on the device. Zero
(0) if the device does not allow the value to be set. See
ethF… | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2928.2.2.1.1.1.1.8 |
| ethDevCapMACMode The MAC mode capabilities of forwarding functions on the
device. Describes all supported values of the MAC modes
setting. See ethFwdMACMode. | column | Bits | .1.3.6.1.4.1.2928.2.2.1.1.1.1.9 |