snmpEnable
MS-SWITCH30-MIB ·
.1.3.6.1.4.1.3181.10.3.22.2
Object
scalar
r/w
Integer32
This entry contains the bitwise information which SNMP version is enabled. Bit 0: SNMP v1 enabled Bit 1: SNMP v2c enabled Bit 2: SNMP v3 enabled It is not allowed to disable an interface via itself or to support v1/v2c at the same time as v3 is enabled. So v1 or v2c can only be enabled via this entry if v3 is disabled. Further changes have to be done via another Interface.
Context
- MIB
- MS-SWITCH30-MIB
- OID
.1.3.6.1.4.1.3181.10.3.22.2- Type
- scalar
- Access
- readwrite
- Status
- current
- Parent
- snmpinterface
- Siblings
- 9
Syntax
Integer32
Values & Constraints
Object Constraints
range: 0-7
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| snmpSupport This entry contains the bitwise information
which SNMP version is supported.
Bit 0: SNMP v1 supported
Bit 1: SNMP v2c supported
Bit 2: SNMP v3 supported | scalar | Integer32 | .1.3.6.1.4.1.3181.10.3.22.1 |
| snmpTrapDestTable This table contains information regarding
the snmp trap configuration for several
destinations. | table | - | .1.3.6.1.4.1.3181.10.3.22.10 |
| snmpApplyMode If this entry is set to '1' changes due
to 'set...' commands are immediately applied
to the switch and saved in the configuration.
If it is set to '2' changed are also applied
… | scalar | Enumeration | .1.3.6.1.4.1.3181.10.3.22.3 |
| snmpApply This entry only has an effect if 'snmpApplyMode'
is not set to '1', which is the normal operation.
In this case the changed configuration will be
applied to the switch (if set to… | scalar | Enumeration | .1.3.6.1.4.1.3181.10.3.22.4 |
| snmpTrapTest This entry triggers a trap event without
the regarding system event took place.
No change to the device will be done.
This entry can be used to test the trap
destination config… | scalar | Enumeration | .1.3.6.1.4.1.3181.10.3.22.5 |
| snmpTrapDestCount The number of supported trap destinations
on this system. | scalar | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.3181.10.3.22.6 |
| snmpCommunityRead This is the string used as community name
in SNMP Get and GetNext requests. | scalar | OctetString | .1.3.6.1.4.1.3181.10.3.22.7 |
| snmpCommunityWrite This is the string used as community name
in SNMP Set operations. | scalar | OctetString | .1.3.6.1.4.1.3181.10.3.22.8 |
| snmpTrapEnable This entry contains the information if
snmp traps are globally enabled or not. | scalar | Enumeration | .1.3.6.1.4.1.3181.10.3.22.9 |