juniNtpClientAdminStatus
Juniper-System-Clock-MIB ·
.1.3.6.1.4.1.4874.2.2.56.2.2.1
Object
By enabling/disabling the NTP admin status, the router is enabled/
disabled to run as NTP client for the correction and synchronization of
the system clock time with the reliable time sources (stratum time
servers). At any given time, only one NTP client can run on any router
on the system.
Sets the NTP admin status along with the routerIndex where NTP client
has be enabled in that router context.
Context
- MIB
- Juniper-System-Clock-MIB
- OID
.1.3.6.1.4.1.4874.2.2.56.2.2.1- Type
- scalar
- Access
- readwrite
- Status
- current
- Parent
- juniNtpClient
- Siblings
- 4
Syntax
Juniper-TCJuniEnable
- Source
- Juniper-TCJuniEnable
- Base type
Enumeration
Values & Constraints
Type Values
0 | disable |
1 | enable |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| juniNtpClientSystemRouterIndex The index of the router to be enabled or disabled as the system-wide
NTP client. Always set along with juniNtpClientAdminStatus.
This is also the router context when N… | scalar | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.4874.2.2.56.2.2.2 |
| juniNtpClientPacketSourceIfIndex When the NTP client sends an NTP packet, the source IP address is
normally set to the address of the interface through which the NTP
packet is sent.
Sets all the outgoi… | scalar | Integer32 | .1.3.6.1.4.1.4874.2.2.56.2.2.3 |
| juniNtpClientBroadcastDelay Allows to set the estimated round-trip broadcast delay between the
system client and broadcast servers (peers). | scalar | microseconds Integer32 | .1.3.6.1.4.1.4874.2.2.56.2.2.4 |
| juniNtpClientIfTable Lists all the NTP client's interfaces enabled for NTP. All the IP
interfaces on the NTP client are by default enabled for NTP
communications and can be disabled individually on e… | table | - | .1.3.6.1.4.1.4874.2.2.56.2.2.5 |