provDot3OamPortEnabled
IPE-DOT3OAM-MIB ·
.1.3.6.1.4.1.119.2.3.69.501.5.46.1.1.3
Object
column
r/w
EnableDisableValue
This object is used to provision the default administrative OAM
mode for the interface. This object represents the desired state
of OAM for this interface.
This object always starts disabled state until explicit
management action or configuration information retained by the
system causes a transition to the enabled state. When enabled,
Ethernet OAM will attempt to operate over this interface.
Context
- MIB
- IPE-DOT3OAM-MIB
- OID
.1.3.6.1.4.1.119.2.3.69.501.5.46.1.1.3- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- provDot3OamPortEntry
- Table
- provDot3OamPortTable
- Siblings
- 8
Syntax
EnableDisableValue
- Source
- EnableDisableValue
- Base type
Enumeration
Values & Constraints
Type Values
0 | invalid |
1 | disable |
2 | enable |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| provDot3OamPortIfIndex Index of this table. | column | IF-MIBInterfaceIndex | .1.3.6.1.4.1.119.2.3.69.501.5.46.1.1.1 |
| provDot3OamPortNEAddress reserved. | column | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.119.2.3.69.501.5.46.1.1.2 |
| provDot3OamPortMode This object configures the mode of OAM operation for this
interface. OAM on Ethernet interfaces may be in 'active' mode or
'passive' mode. These two modes differ in that active mo… | column | Enumeration | .1.3.6.1.4.1.119.2.3.69.501.5.46.1.1.4 |
| provDot3OamTxPduRepetitionTimes This object configures the number of notification OAMPDUs when
the critical event occurs. | column | Integer32 | .1.3.6.1.4.1.119.2.3.69.501.5.46.1.1.5 |
| provDot3OamLocalLinkLostTimer This object configures the detection time of losing the OAM Link
state. | column | seconds Integer32 | .1.3.6.1.4.1.119.2.3.69.501.5.46.1.1.6 |
| provDot3OamTxPduCounts This object configures the maximum transmission counts of slow
protocol PDUs excluding DyingGasp and Critical Event PDUs. | column | Integer32 | .1.3.6.1.4.1.119.2.3.69.501.5.46.1.1.7 |
| provDot3OamLoopbackIgnoreRx If ignore(1) is set, the OAM entity ignores Loopback Request
OAMPDUs from peer OAM entity, and the OAM entity can only
initiate loopback locally. It is necessary to change the val… | column | Enumeration | .1.3.6.1.4.1.119.2.3.69.501.5.46.1.1.8 |
| provDot3OamLlfCriticalEvent If enable is set, the OAM entity sends OAMPDUs with Critical
Event flag when the LLF control is notified. | column | EnableDisableValue | .1.3.6.1.4.1.119.2.3.69.501.5.46.1.1.9 |