hpnicfMainPseLegacy
HPN-ICF-POWER-ETH-EXT-MIB ·
.1.3.6.1.4.1.11.2.14.11.15.2.14.2.1.6
Object
column
r/w
Enumeration
Describes or controls the legacy mode on slot which must be enabled firstly. Legacy mode: standard or nonstandard PD detection mode.
Context
- MIB
- HPN-ICF-POWER-ETH-EXT-MIB
- OID
.1.3.6.1.4.1.11.2.14.11.15.2.14.2.1.6- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- hpnicfMainPseEntry
- Table
- hpnicfMainPseTable
- Siblings
- 6
Syntax
Enumeration
Values & Constraints
Enumerated Values
0 | enable |
1 | disable |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| hpnicfMainPsePowerLimit The object specifies the power limit set for the unit as a whole.
The PoE unit will already have a nominal power defined by the
IETF Power MIB [1] pethMainPsePower object. This O… | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.11.2.14.11.15.2.14.2.1.1 |
| hpnicfMainPseAveragePower The object specifies the average power which has been consumed
by the port. It is a read/write integer value with units of
Watts (note - Watts is chosen instead of milliWatts her… | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.11.2.14.11.15.2.14.2.1.2 |
| hpnicfMainPsePeakPower The object specifies the peak power which has been consumed for PoE.
It is defined as the highest measured value of power in milliWatts
that has been consumed at any one point in … | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.11.2.14.11.15.2.14.2.1.3 |
| hpnicfMainGuaranteedPowerRemaining The object specifies the amount of power remaining in the guaranteed
power pool. Each time a port is placed into guaranteed mode it
reserves a set amount of power out of the tota… | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.11.2.14.11.15.2.14.2.1.4 |
| hpnicfMainPsePriorityMode Describes or controls the priority mode on slot which must be
enabled firstly. When a new board is inserted, and the power is
over-load, a value of disconnection(0) means that th… | column | Enumeration | .1.3.6.1.4.1.11.2.14.11.15.2.14.2.1.5 |
| hpnicfMainPsePowerPriority Describes or controls the priority of the PSE. The priority
will be used by the PSE policy to prevent from power overloading.
If the priority of PSE is set to critical, the PSE w… | column | Enumeration | .1.3.6.1.4.1.11.2.14.11.15.2.14.2.1.7 |