upsOutputPowerFactorgen
GESINGLEUPS-MIB ·
.1.3.6.1.4.1.818.1.1.10.4.4.1.6
Object
column
0.01 cos phi Integer32
The present output power factor. The returned value correspond to the cosf of the load. A positive value indicate an inductive load; a negative value indicate a capacitive load; value 1 indicate a resistive load. If the measure is not available due to a small load for a consistent calculation, the NA value is then returned.(*)
Context
- MIB
- GESINGLEUPS-MIB
- OID
.1.3.6.1.4.1.818.1.1.10.4.4.1.6- Type
- column
- Access
- readonly
- Status
- current
- Units
- 0.01 cos phi
- Parent
- upsOutputGenEntry
- Table
- upsOutputGenTable
- Siblings
- 7
Syntax
0.01 cos phi Integer32
Values & Constraints
Object Constraints
range: -99-100
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| upsOutputLineIndexgen The output line identifier.(*) | column | PositiveInteger32 | .1.3.6.1.4.1.818.1.1.10.4.4.1.1 |
| upsOutputVoltagegen The present output voltage.(*) | column | RMS Volts NonNegativeInteger32 | .1.3.6.1.4.1.818.1.1.10.4.4.1.2 |
| upsOutputCurrentgen The present output current.(*) | column | 0.1 RMS Amp NonNegativeInteger32 | .1.3.6.1.4.1.818.1.1.10.4.4.1.3 |
| upsOutputPowergen The present output true power.(*) | column | Watts NonNegativeInteger32 | .1.3.6.1.4.1.818.1.1.10.4.4.1.4 |
| upsOutputPercentLoadgen The percentage of the UPS power capacity presently
being used on this output line, i.e., the greater of
the percent load of true power capacity and the
percent load of VA.(*) | column | percent Integer32 | .1.3.6.1.4.1.818.1.1.10.4.4.1.5 |
| upsOutputPeakCurrentgen The present output peak current.(*) | column | Amps SNMPv2-SMIInteger32 | .1.3.6.1.4.1.818.1.1.10.4.4.1.7 |
| upsOutputShareCurrentgen In a parallel system ideally all the UPS are requested to
contribute to the load with the same amount of current,
i.e. with no current share. The current share occurs when an
UP… | column | Amps SNMPv2-SMIInteger32 | .1.3.6.1.4.1.818.1.1.10.4.4.1.8 |