flWorkNetPortSTPEnable
FL-MGD-INFRASTRUCT-MIB ·
.1.3.6.1.4.1.4346.11.11.4.2.2.1.10
Object
column
deprecated
r/w
Enumeration
Firmware with Rapid Spanning Tree:
The value of this object is equal to the status
of the object dot1dStpPortEnable.
When Rapid Spanning Tree is operating this objects
handles the behaviour of the port regarding
bridge protocol data units (BPDUs).
Set this object to disable(1) the interface doesn't
send BPDUs when Rapid Spanning Tree operation is
enabled. BPDUs will be send by this interface if
the object is set to enable(2).
Firmware with Spanning Tree:
When spanning tree has been activated (see object
flSwitchCtrlSpanTree) this object handles the behaviour
of the port regarding bridge protocol data units (BPDUs).
Set this object to disable(1) the interface doesn't
send BPDUs when Spanning Tree operation is enabled.
BPDUs will be send by this interface if the object
is set to enable(2).
When the port stp status has been set to disable(1) the port
uses fast forwarding to change from the port state disabled
into the port state forwarding immediately (see object
dot1dStpPortState of the bridge mib (rfc 1493).
Context
- MIB
- FL-MGD-INFRASTRUCT-MIB
- OID
.1.3.6.1.4.1.4346.11.11.4.2.2.1.10- Type
- column
- Access
- readwrite
- Status
- deprecated
- Parent
- flWorkNetPortEntry
- Table
- flWorkNetPortTable
- Siblings
- 22
Syntax
Enumeration
Values & Constraints
No enumerated values or constraints recorded.
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| flWorkNetPortIndex This object identifies the port. This value
is never greater then flWorkNetPortCapacity. | column | Integer32 | .1.3.6.1.4.1.4346.11.11.4.2.2.1.1 |
| flWorkNetPortIfIndex The ifIndex of this application 'logical port' (see
interface table of the mib2). | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.4346.11.11.4.2.2.1.11 |
| flWorkNetPortLLWHPort A value that uniquely identifies a application 'logical port'
(i.e., IEEE 802.3ad Aggregator) in the stack. This is
a 'Layered Linear With Holes' (LLWH) port number that may may h… | column | Integer32 | .1.3.6.1.4.1.4346.11.11.4.2.2.1.12 |
| flWorkNetPortType The media type of this port. | column | SNMPv2-TCDisplayString | .1.3.6.1.4.1.4346.11.11.4.2.2.1.13 |
| flWorkNetPortModuleName The textual name of this module. | column | SNMPv2-TCDisplayString | .1.3.6.1.4.1.4346.11.11.4.2.2.1.14 |
| flWorkNetPortInterfaceName The textual name of this interface
according to the labeling of the device. | column | SNMPv2-TCDisplayString | .1.3.6.1.4.1.4346.11.11.4.2.2.1.15 |
| flWorkNetPortPriorityLevel Choose the priority level for the incoming
packets of one port in the switch
by selecting a level in the range from 0 to 7. | column | Integer32 | .1.3.6.1.4.1.4346.11.11.4.2.2.1.16 |
| flWorkNetPortPofTransmittingPower This objects shows the selected
transmitting power of POF ports.
For polymer fiber (POF) paths < 20 m
(65.62 ft.) the transmission power must
be reduced by sliding the switch on t… | column | Enumeration | .1.3.6.1.4.1.4346.11.11.4.2.2.1.17 |
| flWorkNetPortStpMode The mode of Spanning Tree Protocol the
port is currently running. The value stp(1)
indicates the Spanning Tree Protocol,
rstp(2) indicates the Rapid Spanning
Tree Protocol and non… | column | Enumeration | .1.3.6.1.4.1.4346.11.11.4.2.2.1.18 |
| flWorkNetPortLinkState Get back the current state of the port link.
The state farEndFault(3) indicates that this
fiber optic port receives a signal but the
other port of the path don't get a signal.
Th… | column | Enumeration | .1.3.6.1.4.1.4346.11.11.4.2.2.1.2 |
| flWorkNetPortFlowControl Setting this object to disable(1) inactivates the
flow control mechanism for this port. | column | Enumeration | .1.3.6.1.4.1.4346.11.11.4.2.2.1.20 |
| flWorkNetPortMaxFrameSize This object configures the maximum transmission unit(MTU) or
the size of the largest packet that can be sent/received on the
interface. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.4346.11.11.4.2.2.1.21 |
| flWorkNetPortJumboFrame This object enables/disables jumbo frames on an interface. | column | Enumeration | .1.3.6.1.4.1.4346.11.11.4.2.2.1.22 |
| flWorkNetPortCableLength The length of the table connected to this port in meters. | column | SNMPv2-TCDisplayString | .1.3.6.1.4.1.4346.11.11.4.2.2.1.23 |
| flWorkNetPortPHYcompatibility This object activates some compatibility modes for PHY. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.4346.11.11.4.2.2.1.24 |
| flWorkNetPortSpeed The current interface's bandwidth in bits per second. | column | SNMPv2-SMIGauge32 | .1.3.6.1.4.1.4346.11.11.4.2.2.1.3 |
| flWorkNetPortDuplexMode The current duplex mode of this port. | column | Enumeration | .1.3.6.1.4.1.4346.11.11.4.2.2.1.4 |
| flWorkNetPortNegotiation This object gives an information
if auto negotiation is active or not. | column | Enumeration | .1.3.6.1.4.1.4346.11.11.4.2.2.1.5 |
| flWorkNetPortName The textual name of this interface, e.g., 'robot 1'. | column | SNMPv2-TCDisplayString | .1.3.6.1.4.1.4346.11.11.4.2.2.1.6 |
| flWorkNetPortEnable This object is enable(2) when this interface is enabled and
disable(1) when it is disabled. A disabled interfaces doesn't
send any data packets. | column | Enumeration | .1.3.6.1.4.1.4346.11.11.4.2.2.1.7 |
| flWorkNetPortLinkMonitoring Setting this object to enable(2) activates the
link monitoring for this. | column | Enumeration | .1.3.6.1.4.1.4346.11.11.4.2.2.1.8 |
| flWorkNetPortModus The modus of this port defined by the user:
autonegotiation(1) - auto negotiation
half-10(2) - 10 MBit Half Duplex
full-10(3) - 10 MBit Full Duplex
half-1… | column | Enumeration | .1.3.6.1.4.1.4346.11.11.4.2.2.1.9 |