flSwitchLagDeletePort
FL-MGD-INFRASTRUCT-MIB ·
.1.3.6.1.4.1.4346.11.11.15.8.2.1.8
Object
Set to a non 0 value to remove a port from the LAG. Values correspond to ifIndex values in the ifTable.
Context
- MIB
- FL-MGD-INFRASTRUCT-MIB
- OID
.1.3.6.1.4.1.4346.11.11.15.8.2.1.8- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- flSwitchLagSummaryEntry
- Table
- flSwitchLagSummaryTable
- Siblings
- 14
Syntax
SNMPv2-SMIInteger32
- Source
- SNMPv2-SMIInteger32
- Base type
Integer32
Values & Constraints
Type Constraints
range: -2147483648..2147483647
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| flSwitchLagIndex This value corresponds with the LAG interface in the ifTable. | column | Integer32 | .1.3.6.1.4.1.4346.11.11.15.8.2.1.1 |
| flSwitchLagType static(1) - This LAG is staticly maintained.
dynamic(2) - This LAG is dynamicly maintained. | column | Enumeration | .1.3.6.1.4.1.4346.11.11.15.8.2.1.10 |
| flSwitchLagStaticCapability enable(1) - Static capability is enabled for this LAG interface
disable(2) - Static capability is disabled for this LAG interface | column | Enumeration | .1.3.6.1.4.1.4346.11.11.15.8.2.1.11 |
| flSwitchLagHashOption Valid values correspond to
1 (=Source MAC, VLAN, EtherType, and incoming port
associated with the packet)
2 (=Destination MAC, VLAN, EtherType, and incoming … | column | Integer32 | .1.3.6.1.4.1.4346.11.11.15.8.2.1.12 |
| flSwitchLagMaxFrameSize This object configures the maximum transmission unit(MTU) or
the size of the largest packet that can be sent/received on the
interface. | column | Integer32 | .1.3.6.1.4.1.4346.11.11.15.8.2.1.13 |
| flSwitchLagJumboFrame This object enables/disables jumbo frames on an interface. | column | Enumeration | .1.3.6.1.4.1.4346.11.11.15.8.2.1.14 |
| flSwitchLagLinkStatus The current operational state of the LAG interface. | column | Enumeration | .1.3.6.1.4.1.4346.11.11.15.8.2.1.15 |
| flSwitchLagMode static(2) - This LAG is staticly maintained.
lacp-passiv(3) - This LAG is dynamicly maintained.Pdus are
only send when the partner does.
lacp-activ(… | column | Enumeration | .1.3.6.1.4.1.4346.11.11.15.8.2.1.16 |
| flSwitchLagName The associated name of the LAG used during creation. | column | OctetString | .1.3.6.1.4.1.4346.11.11.15.8.2.1.2 |
| flSwitchLagLinkTrap Configures sending Link Up/Down traps when the LAG interface goes Up or Down. | column | Enumeration | .1.3.6.1.4.1.4346.11.11.15.8.2.1.4 |
| flSwitchLagAdminMode Administratively enables or disables this LAG interface. | column | Enumeration | .1.3.6.1.4.1.4346.11.11.15.8.2.1.5 |
| flSwitchLagStpMode If Dot1d is enabled, the valid values are:
dot1d(1), fast(2), and off(3)
If Dot1s is enabled, the valid values are:
off(3) and dot1s(4) | column | Enumeration | .1.3.6.1.4.1.4346.11.11.15.8.2.1.6 |
| flSwitchLagAddPort Set to a non 0 value to add a port to the LAG. Values correspond to
ifIndex values in the ifTable.
Note: The duplex type for the port to be added must be full dupl… | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.4346.11.11.15.8.2.1.7 |
| flSwitchLagStatus active(1) - This LAG is enabled.
destroy(6) - Set to this value to remove the LAG. | column | SNMPv2-TCRowStatus | .1.3.6.1.4.1.4346.11.11.15.8.2.1.9 |