flSwitchLagAddPort

FL-MGD-INFRASTRUCT-MIB · .1.3.6.1.4.1.4346.11.11.15.8.2.1.7

MIB view Table view

Object

column r/w SNMPv2-SMIInteger32

Set to a non 0 value to add a port to the LAG.  Values correspond to
ifIndex values in the ifTable.
              
Note: The duplex type for the port to be added must be full duplex
and the port to be added must operate at the same speed as previously 
added port(s), if any.

Context

MIB: FL-MGD-INFRASTRUCT-MIB
OID: .1.3.6.1.4.1.4346.11.11.15.8.2.1.7
Type: column
Access: readwrite
Status: current
Parent: flSwitchLagSummaryEntry
Table: flSwitchLagSummaryTable
Siblings: 14

Syntax

SNMPv2-SMIInteger32

Source: SNMPv2-SMIInteger32
Base type: Integer32

Values & Constraints

Type Constraints

range: -2147483648..2147483647

Related Objects

Sibling Objects

Object	Type	Syntax	OID
flSwitchLagIndex This value corresponds with the LAG interface in the ifTable.	column	Integer32	`.1.3.6.1.4.1.4346.11.11.15.8.2.1.1`
flSwitchLagType static(1) - This LAG is staticly maintained. dynamic(2) - This LAG is dynamicly maintained.	column	Enumeration	`.1.3.6.1.4.1.4346.11.11.15.8.2.1.10`
flSwitchLagStaticCapability enable(1) - Static capability is enabled for this LAG interface disable(2) - Static capability is disabled for this LAG interface	column	Enumeration	`.1.3.6.1.4.1.4346.11.11.15.8.2.1.11`
flSwitchLagHashOption Valid values correspond to 1 (=Source MAC, VLAN, EtherType, and incoming port associated with the packet) 2 (=Destination MAC, VLAN, EtherType, and incoming …	column	Integer32	`.1.3.6.1.4.1.4346.11.11.15.8.2.1.12`
flSwitchLagMaxFrameSize This object configures the maximum transmission unit(MTU) or the size of the largest packet that can be sent/received on the interface.	column	Integer32	`.1.3.6.1.4.1.4346.11.11.15.8.2.1.13`
flSwitchLagJumboFrame This object enables/disables jumbo frames on an interface.	column	Enumeration	`.1.3.6.1.4.1.4346.11.11.15.8.2.1.14`
flSwitchLagLinkStatus The current operational state of the LAG interface.	column	Enumeration	`.1.3.6.1.4.1.4346.11.11.15.8.2.1.15`
flSwitchLagMode static(2) - This LAG is staticly maintained. lacp-passiv(3) - This LAG is dynamicly maintained.Pdus are only send when the partner does. lacp-activ(…	column	Enumeration	`.1.3.6.1.4.1.4346.11.11.15.8.2.1.16`
flSwitchLagName The associated name of the LAG used during creation.	column	OctetString	`.1.3.6.1.4.1.4346.11.11.15.8.2.1.2`
flSwitchLagLinkTrap Configures sending Link Up/Down traps when the LAG interface goes Up or Down.	column	Enumeration	`.1.3.6.1.4.1.4346.11.11.15.8.2.1.4`
flSwitchLagAdminMode Administratively enables or disables this LAG interface.	column	Enumeration	`.1.3.6.1.4.1.4346.11.11.15.8.2.1.5`
flSwitchLagStpMode If Dot1d is enabled, the valid values are: dot1d(1), fast(2), and off(3) If Dot1s is enabled, the valid values are: off(3) and dot1s(4)	column	Enumeration	`.1.3.6.1.4.1.4346.11.11.15.8.2.1.6`
flSwitchLagDeletePort Set to a non 0 value to remove a port from the LAG. Values correspond to ifIndex values in the ifTable.	column	SNMPv2-SMIInteger32	`.1.3.6.1.4.1.4346.11.11.15.8.2.1.8`
flSwitchLagStatus active(1) - This LAG is enabled. destroy(6) - Set to this value to remove the LAG.	column	SNMPv2-TCRowStatus	`.1.3.6.1.4.1.4346.11.11.15.8.2.1.9`