connUnitPortControl

This object is used to control the addressed
connUnit's port. Valid commands are:
              
resetConnUnitPort: If the addressed connUnit
    allows this operation to be performed to this
    port, the addressed port performs a
    vendor-specific 'reset' operation. Examples of
    these operations are: the Link Reset protocol,
    the Loop Initialization protocol, or a
    resynchronization occurring between the
    transceiver in the addressed port to the
    transceiver that the port is connected to.
              
bypassConnUnitPort: If the addressed connUnit
    allows this operation to be performed to this
    port, the addressed port performs a
    vendor-specific 'bypass' operation. Examples of
    these operations are:
    transitioning from online to offline, a
    request(NON-PARTICIPATING) command to the
    Loop Port state machine, or removal of the
    port from an arbitrated loop by a hub.
              
unbypassConnUnitPort: If the addressed connUnit
    allows this operation to be performed to this
    port, the addressed port performs a
    vendor-specific 'unbypass' operation. Examples
    of these operations are:
    the Link Failure protocol, a
    request(PARTICIPATING) command to the
    Loop Port state machine, or addition of the
    port to an arbitrated loop by a hub.
              
offlineConnUnitPort: If the addressed connUnit
    allows this operation to be performed to this
    port, the addressed port performs a
    vendor-specific 'offline' operation. Examples
    of these operations are:
    disabling a port's transceiver, the Link
    Failure protocol, request(NON-PARTICIPATING)
    command to the Loop Port state machine, or
    removal of the port from an arbitrated loop
    by a hub.
              
onlineConnUnitPort: If the addressed connUnit
    allows this operation to be performed to this
    port, the addressed port performs a
    vendor-specific 'online' operation. Examples
    of these operations are:
    enabling a port's transceiver, the Link
    Failure protocol, request(PARTICIPATING)
    command to the Loop Port state machine, or
    addition of the port from an arbitrated loop
    by a hub.
              
resetConnUnitPortCounters: If the addressed connUnit
    allows this operation to be performed to this
    port, the addressed port statistics table counters
    will be set to zero.
              
NOTE: Each implementation may chose not to allow
any or all of these values on a SET. On a read, if
you do not support write, then return invalid. Otherwise
return the last control operation attempted.

MIB

FCMGMT-MIB

OID

.1.3.6.1.3.94.1.10.1.16

Type

column

Access

readwrite

Status

mandatory

Parent

connUnitPortEntry

Table

connUnitPortTable

Siblings

22