esModuleStatus

ES-MODULE-MIB · .1.3.6.1.4.1.437.1.1.2.1.2.1.1.2

Object

column mandatory Enumeration

Current operational status of the module. This value
is the same as swPortStatus for the corresponding
switched port.  Possible values are:
enabled              : normal operation (transmit and receive)
disabled-mgmt        : disabled by explicit management action
suspended-linkbeat   : suspended due to absence of linkbeat
suspended-jabber     : suspended because port is jabbering
suspended-violation  : suspended due to a secured address
                       violation
disabled-violation   : disabled due to a secured address
                       violation
suspended-not-present: there is no module inserted in the
                       expansion slot.
suspended-not-recognized: there is an unrecognized module inserted
                       in the expansion slot.
reset                : the module is currently in the reset state
suspended-ringdown   : suspended due to a ring-down condition
suspended-stp        : Spanning Tree Protocol non forwarding state
disabled-self-test   : disabled because port fails self-test
suspended-atm-lane-down: Non-trunk ATM module using LANE suspended
                         because there is no active LANE client.
suspended-no-vlan    : the module is not assigned to a VLAN or the
                       assigned VLAN does not exist.
disabled-no-vlan     : vlan of the module is suspended or does not exist.
suspended-atm-network-down: ATM module suspended due to ATM network down,
                            or ATM physical layer down.
suspended-disl       : suspended while module is negotiating trunking
                       mode using the Dynamic Inter Switch Link
                       protocol.
              
The default value is enabled(1), unless POST has detected
a failure on the module switch port, in which case, it is
disabled-mgmt(2).  Any esModuleStatus of type disabled-xxxx (except
disabled-self-test) is saved across a system reset so a module
may also come up with such a status.

Context

MIB: ES-MODULE-MIB
OID: .1.3.6.1.4.1.437.1.1.2.1.2.1.1.2
Type: column
Access: readonly
Status: mandatory
Parent: esModuleEntry
Table: esModuleTable
Siblings: 18

Syntax

Enumeration

Values & Constraints

Enumerated Values

`1`	enabled
`2`	disabled-mgmt
`3`	suspended-linkbeat
`4`	suspended-jabber
`5`	suspended-violation
`7`	disabled-violation
`9`	suspended-not-present
`10`	suspended-not-recognized
`11`	reset
`12`	suspended-ringdown
`13`	suspended-stp
`14`	disabled-self-test
`15`	enabled-degraded
`16`	suspended-atm-lane-down
`17`	suspended-no-vlan
`18`	disabled-no-vlan
`19`	suspended-atm-network-down
`20`	suspended-disl

Related Objects

Sibling Objects

Object	Type	Syntax	OID
esModuleIndex mandatory This object identifies the module for which this entry contains information. This value is never greater than esModuleCapacity.	column	Integer32	`.1.3.6.1.4.1.437.1.1.2.1.2.1.1.1`
esModuleLastStatusChange mandatory Contains the value of sysUpTime at the time that the value of the esModuleStatus object for this module last changed. A value of zero indicates that the group's operational status…	column	RFC1155-SMITimeTicks	`.1.3.6.1.4.1.437.1.1.2.1.2.1.1.10`
esModuleCollisionPeriods mandatory Contains the count of times the firmware has toggled the front panel module collision LED from the off state to the on state. Successive reads of the counter may network manageme…	column	RFC1155-SMICounter	`.1.3.6.1.4.1.437.1.1.2.1.2.1.1.11`
esModuleLinkDisplayMap mandatory A bit array where the presence of a particular bit indicates a lit link LED for a module port. Each octet within the value of this object specifies a set of eight l…	column	OctetString	`.1.3.6.1.4.1.437.1.1.2.1.2.1.1.12`
esModuleDisabledDisplayMap mandatory A bit array where the presence of a particular bit indicates a lit disabled LED for a module port. Each octet within the value of this object specifies a set of eig…	column	OctetString	`.1.3.6.1.4.1.437.1.1.2.1.2.1.1.13`
esModuleBroadcastStormBlocked mandatory The current broadcast forwarding status of this module. If this module is blocked by broadcast storm control, the switch drops all broadcasts received from the module. If the modu…	column	Enumeration	`.1.3.6.1.4.1.437.1.1.2.1.2.1.1.14`
esModuleFirmwareVersion mandatory This object returns the version number of the firmware stored in FLASH memory on the module. The string has the format 'v1.00' for the FDDI module. For the ATM module, the string…	column	OctetString	`.1.3.6.1.4.1.437.1.1.2.1.2.1.1.15`
esModuleBOOTCodeVersion mandatory This object returns the version number of the BOOT code stored in permanent FLASH memory on the module. The string has the format 'v1.00' for the FDDI module. For the ATM module,…	column	OctetString	`.1.3.6.1.4.1.437.1.1.2.1.2.1.1.16`
esModuleFlashStatus mandatory A string of up to 80 characters indicating the status of the firmware stored in the module's FLASH memory. The string includes the firmware revision, the data and time of the las…	column	OctetString	`.1.3.6.1.4.1.437.1.1.2.1.2.1.1.17`
esModuleResetToFactoryDefaults mandatory Setting this object to reset(2) will cause the settings on the module to revert to factory defaults. The module will then be reset by the system. The module's packet operations …	column	Enumeration	`.1.3.6.1.4.1.437.1.1.2.1.2.1.1.18`
esModuleSwPortIndex mandatory This is the value of swPortIndex object in the STANDALONE-ETHERNET-SWITCH-MIB corresponding to the module.	column	Integer32	`.1.3.6.1.4.1.437.1.1.2.1.2.1.1.19`
esModuleAdminStatus mandatory By explicit management action, change the port status to either enabled : normal status (transmit and receive) disabled-mgmt: port is no longer in use. This value is the same…	column	Enumeration	`.1.3.6.1.4.1.437.1.1.2.1.2.1.1.3`
esModuleDescr mandatory A text string which includes the full name and version identification of the module's hardware type.	column	OctetString	`.1.3.6.1.4.1.437.1.1.2.1.2.1.1.4`
esModuleID mandatory A text representation of the Cisco specified identifier for the installed module, or 'notPresent'.	column	OctetString	`.1.3.6.1.4.1.437.1.1.2.1.2.1.1.5`
esModuleVersion mandatory The Cisco specified unique identification for the module version, ranging from 1 to 254.	column	Integer32	`.1.3.6.1.4.1.437.1.1.2.1.2.1.1.6`
esModuleObjectID mandatory The vendor's authoritative identification of the module. This value may be allocated within the SMI enterprises subtree (1.3.6.1.4.1) and provides a straight-forward and unambigu…	column	ObjectIdentifier	`.1.3.6.1.4.1.437.1.1.2.1.2.1.1.7`
esModulePortCapacity mandatory The number of external port attachments provided by the module.	column	Integer32	`.1.3.6.1.4.1.437.1.1.2.1.2.1.1.8`
esModuleReset mandatory Setting this object to reset causes the module to be forced into a reset state. The reset state is a module specific condition in which the module's packet operations will cease …	column	Enumeration	`.1.3.6.1.4.1.437.1.1.2.1.2.1.1.9`