erpsInstanceWtrTimer
ECS4100-MIB ·
.1.3.6.1.4.1.259.10.1.46.1.62.9.1.6
Object
column
r/w
Integer32
Configures the value of the wait-to-restore timer which is used by the RPL owner node to prevent frequent switching operations that may be caused by intermittent failures. The range is in 1 minute steps between 1 and 12 minutes with a default value of 5 minutes. This object will not take effect for the non RPL owner node.
Context
- MIB
- ECS4100-MIB
- OID
.1.3.6.1.4.1.259.10.1.46.1.62.9.1.6- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- erpsInstanceEntry
- Table
- erpsInstanceTable
- Siblings
- 31
Syntax
Integer32
Values & Constraints
Object Constraints
range: 1-12
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| erpsInstanceIndex An index that uniquely identifies an entry in the
erpsInstanceTable. | column | Integer32 | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.1 |
| erpsInstanceEastMepId Configures a CFM Down MEP on east ring port. A down MEP can be
uniquely select by given a MEPID, instance's MEG level, and
instance's control VLAN ID. A value of 0 means no east M… | column | Integer32 | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.10 |
| erpsInstanceMajorRingIndex An index that uniquely identifies an entry in the
erpsInstanceTable. A value of 0 means this instance has no major
ring.
Notes: This objest can not be configured if erpsRingEastPo… | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.11 |
| erpsInstancePropagateTC Set to enabled(1) to transmit topology change signal to the
major ring. It will not take effect if erpsInstanceMajorRingIndex
doesn't designated. | column | Enumeration | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.12 |
| erpsInstanceNonRevertive For each instances of a ring is configured independently; as a
result of that, the recovery mechanism is invoked separately for
each instance according to its own configuration of… | column | Enumeration | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.14 |
| erpsInstanceRapsDefMac Set to enabled(1) to use R-APS default MAC. If this configuration
enabled then R-APS default MAC 01-19-A7-00-00-01 shall be
used as destination address for the R-APS PDUs. | column | Enumeration | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.15 |
| erpsInstanceRapsWithoutVc Set to enabled(1) To specify the ERP instance as a sbu ring without
virtual channel. | column | Enumeration | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.16 |
| erpsInstanceVersion Set to v2(2) to enable ERPS v2 operation. | column | Enumeration | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.17 |
| erpsInstanceInclusionVlan A bitmap of VLAN groups lists a set of VLAN group IDs protected by this instance.
Inclusion-vlan command is mandatory for each ERP instance
while exclusion-vlan command is optiona… | column | OctetString | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.18 |
| erpsInstancePhysicalRingIndex An index that uniquely identifies an entry in the erpsRingTable.
Associates the ERP instance to a physical ring. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.19 |
| erpsInstanceName Configures a instance and specifies name for the instance. | column | OctetString | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.2 |
| erpsInstanceForcedSwitch Set to west(2) to perform the forced switch command on west
ring port of specified Instance.
Set to east(3) to perform the forced switch command on east
ring port of specified Ins… | column | Enumeration | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.20 |
| erpsInstanceManualSwitch Set to west(2) to perform the manual switch command on west
ring port of specified Instance.
Set to east(3) to perform the manual switch command on east
ring port of specified Ins… | column | Enumeration | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.21 |
| erpsInstanceClear Set to clear(1) to perform the clear command on specified
Instance.
The value noClear(2) will always be displayed when reading. | column | Enumeration | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.22 |
| erpsInstanceClearStatisticsAction This variable is used to clear the counters of specified
instance. Set to clear(1) to perform the clear operation.
The value noClear(2) will always be displayed when reading. | column | Enumeration | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.23 |
| erpsInstanceRowStatus The row status variable, used according to row
installation and removal conventions.
A row entry cannot be modified when the status is
marked as active(1). | column | SNMPv2-TCRowStatus | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.24 |
| erpsInstanceNodeState This value displays the node's current state.
It displays one of the following states
(1) init -- The node is in the init state.
(The node state will stay in init state
… | column | Enumeration | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.25 |
| erpsInstanceWestRingPortState This value displays the west ring port's current state.
It displays one of the following states
(1) unknown -- The port's current state is unknown.
(The port's current state w… | column | Enumeration | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.26 |
| erpsInstanceEastRingPortState This value displays the east ring port's current state.
It displays one of the following states
(1) unknown -- The port's current state is unknown.
(The port's current state w… | column | Enumeration | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.27 |
| erpsInstanceWtrExpire Displays the time remaining in seconds until the
wait-to-restore timer countdown expires.
A value of 0 means no countdown is running. | column | Integer32 | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.28 |
| erpsInstanceWtbExpire Displays the time remaining in ms until the
wait-to-block timer countdown expires.
A value of 0 means no countdown is running. | column | Integer32 | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.29 |
| erpsInstanceMegLevel Configures the maintenance entity group (MEG) level which is
used to provide a communication channel for instance automatic
protection switching (R-APS) information. | column | Integer32 | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.3 |
| erpsInstanceWestRingPortSf This value displays the west ring port's current SF state.
It displays one of the following states
(1) none -- No SF is detected.
(2) detected -- SF is detected. | column | Enumeration | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.30 |
| erpsInstanceEastRingPortSf This value displays the east ring port's current SF state.
It displays one of the following states
(1) none -- No SF is detected.
(2) detected -- SF is detected. | column | Enumeration | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.31 |
| erpsInstanceMultiRplOwnerWarn This value displays the multiple PPL owner warning state.
It displays one of the following states
(1) none -- No multiple PPL owner warning is detected.
(2) detected -- Multiple R… | column | Enumeration | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.32 |
| erpsInstanceWtbTimer Displays the value of the wait-to-block timer in ms
which is used by the RPL owner node when recovering from an
operator command (i.e. FS or MS).
This object will not take effect … | column | Integer32 | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.33 |
| erpsInstanceControlVlanID This is defined as dot1qVlanIndex in the Q-BRIDGE-MIB.
Configures one control VLAN for each ERPS instance. The control
VLAN is used only to send and receive ERPS message. A contro… | column | Integer32 | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.4 |
| erpsInstanceRplType Set to none(1) to make this node act as a normal node.
Set to owner(2) to make this node act as an RPL owner.
Set to neighbor(3) to make this node act as an RPL neighbor. | column | Enumeration | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.5 |
| erpsInstanceGuardTimer Configures the value of the guard timer which is used to
prevent instance nodes from receiving outdated R-APS messages.
The range is in 10 ms steps between 10 ms and 2 seconds,
wi… | column | Integer32 | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.7 |
| erpsInstanceHoldoffTimer Configures the value of the holdoff timer which is used to
prevent reporting error event immediately to protection
switching if the provisioned holdoff timer value is non-zero.
Th… | column | Integer32 | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.8 |
| erpsInstanceWestMepId Configures a CFM Down MEP on west ring port. A down MEP can be
uniquely select by given a MEPID, instance's MEG level, and
instance's control VLAN ID. A value of 0 means no west M… | column | Integer32 | .1.3.6.1.4.1.259.10.1.46.1.62.9.1.9 |