docsIfMCmtsDepiSessionConfigPhyParamsFlag
DOCS-IF-M-CMTS-MIB ·
.1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.15
Object
column
r/w
Bits
When configuring an entry, DOCSIS PHY parameters may be set directly or default values are used to populate the entry. This object indicates which PHY parameter sets need to be sent by the M-CMTS Core in the DEPI session request. A BIT position set to '1' indicates the PHY parameter is set during the DEPI session establishment. In the EQAM indicates the PHY parameters set by the M-CMTS core during the DEPI Session establishment procedure.
Context
- MIB
- DOCS-IF-M-CMTS-MIB
- OID
.1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.15- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- docsIfMCmtsDepiSessionConfigEntry
- Table
- docsIfMCmtsDepiSessionConfigTable
- Siblings
- 26
Syntax
Bits
Values & Constraints
Enumerated Values
0 | frequency |
1 | bandwidth |
2 | power |
3 | modulation |
4 | interleaver |
5 | j83Annex |
6 | symbolRate |
7 | mute |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| docsIfMCmtsDepiSessionConfigIndex The index for entries in this conceptual table. | column | Unsigned32 | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.1 |
| docsIfMCmtsDepiSessionConfigDEPIMode The DEPI mode of operation of this entry
'dmpt' indicates DOCSIS MPT mode (D-MPT)
'psp' indicates Packet Streaming Protocol. | column | Enumeration | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.10 |
| docsIfMCmtsDepiSessionConfigRsrcAllocReq A reference to docsIfMCmtsDepiRsrcAllocIndex of
docsIfMCmtsDepiRsrcAllocTable used in
the DEPI Session setup by the M-CMTS Core to configure
EQAM PHBIDs. M-CMTS uses only the PHBI… | column | Unsigned32 | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.11 |
| docsIfMCmtsDepiSessionConfigCinPhbIdPolicy A list of tags to reference CIN PHB policies in
docsIfMCmtsDepiPhbPolicyTable for this DEPI session.
This object is not meaningful for the EQAM, and reports
a zero … | column | SNMP-TARGET-MIBSnmpTagValue | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.12 |
| docsIfMCmtsDepiSessionConfigSyncEnabled Indicates the DOCSIS Sync message handling at the Edge QAM
based upon PSP or DMPT mode of operation.
In MPT mode 'true' indicates the EQAM MUST perform
Sync TimeStamp correction.… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.13 |
| docsIfMCmtsDepiSessionConfigSyncInterval Indicates the time nominal time interval for
EQAM to insert DOCSIS Sync messages when operating
in PSP mode. In DMPT mode this value is ignored.
The unit reference of this object … | column | docsisSyncSteps Unsigned32 | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.14 |
| docsIfMCmtsDepiSessionConfigChannelFrequency The channel frequency for the Downstream DEPI Session.
A DEPI Session establishment success will update the
corresponding ifIndex entry of docsIfChannelFrequency
with this entry… | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.16 |
| docsIfMCmtsDepiSessionConfigChannelModulation The channel modulation for the Downstream DEPI Session.
A DEPI Session establishment success will update the
corresponding ifIndex entry of docsIfDownChannelModulation
with this … | column | Enumeration | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.17 |
| docsIfMCmtsDepiSessionConfigChannelInterleave The channel Interleaver for the Downstream DEPI Session.
A DEPI Session establishment success will update the
corresponding ifIndex entry of docsIfDownChannelInterleave
with this… | column | Enumeration | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.18 |
| docsIfMCmtsDepiSessionConfigChannelPower The channel power level for the Downstream DEPI Session.
A DEPI Session establishment success will update the
corresponding ifIndex entry of docsIfDownChannelPower
with this ent… | column | DOCS-IF-MIBTenthdBmV | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.19 |
| docsIfMCmtsDepiSessionConfigCableMacIfIndex Defines the MAC domain (ifType docsCableMaclayer)on
which the DEPI Session is being set for an existing M-CMTS
Downstream interface.
This object MUST be set to a v… | column | IF-MIBInterfaceIndexOrZero | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.2 |
| docsIfMCmtsDepiSessionConfigChannelAnnex The channel J.83 Annex type for the Downstream DEPI
Session.
A DEPI Session establishment success will update the
corresponding ifIndex entry of docsIfDownChannelAnnex
with this… | column | Enumeration | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.20 |
| docsIfMCmtsDepiSessionConfigChannelSymbolRateM The value M for the estimation of the DS Symbol Rate
as (10.24 MHz )*M/N | column | Unsigned32 | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.21 |
| docsIfMCmtsDepiSessionConfigChannelSymbolRateN The value N for the estimation of the DS Symbol Rate
as (10.24 MHz )*M/N | column | Unsigned32 | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.22 |
| docsIfMCmtsDepiSessionConfigChannelOutputRate The percentage of the maximum output rate for the
aggregated traffic that is being sent though this
M-CMTS Downstream interface to the QAM channel
associated with this DEPI sess… | column | Unsigned32 | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.23 |
| docsIfMCmtsDepiSessionConfigChannelBurstSize The maximum burst size for the aggregate output rate
of this M-CMTS Downstream Interface. The default value
of this object corresponds to 3 M-CMTS Core payload
MTUs.
This value h… | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.24 |
| docsIfMCmtsDepiSessionConfigStorage The storage realization of the entry.
No columnar values can be changed if the StorageType of
an entry is 'permanent'. | column | SNMPv2-TCStorageType | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.25 |
| docsIfMCmtsDepiSessionConfigRowStatus The status of this conceptual table row entry.
In order to set an entry to the 'active' status,
the MIB objects below must be set to proper values:
Other objects default values ar… | column | SNMPv2-TCRowStatus | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.26 |
| docsIfMCmtsDepiSessionConfigChannelId The downstream channel identification of this M-CMTS
Downstream interface.
During entry creation The M-CMTS Core assigns a
Channel ID if this object is not provided.
When this ob… | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.27 |
| docsIfMCmtsDepiSessionConfigCableMCmtsDownIfIndex Defines the Downstream channel index on which the DEPI
Session is being set.
The set of this object is optional. When this object is not
specified the M-CMTS is ex… | column | IF-MIBInterfaceIndexOrZero | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.3 |
| docsIfMCmtsDepiSessionConfigAddrType The type of InetAddress for
docsIfMCmtsDepiSessionConfigLocalAddr and
docsIfMCmtsDepiSessionConfigRemoteAddr. | column | INET-ADDRESS-MIBInetAddressType | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.4 |
| docsIfMCmtsDepiSessionConfigLocalAddr The InetAddress of the local entity the DEPI Session
is set. | column | INET-ADDRESS-MIBInetAddress | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.5 |
| docsIfMCmtsDepiSessionConfigRemoteAddr The InetAddress of the remote peer the DEPI Session
is set. | column | INET-ADDRESS-MIBInetAddress | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.6 |
| docsIfMCmtsDepiSessionConfigL2TPv3HeaderType Indicates the type of L2TPv3 header being configured for
the DEPI session.
The value 'ip' means L2TPv3 Header Over IP
The value 'udp' means L2TPv3 Header Over UDP. A M-CMTS Core
i… | column | Enumeration | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.7 |
| docsIfMCmtsDepiSessionConfigMethod Indicates the DEPI Tunnel mechanism used for the DEPI
session. Currently only 'l2tpControl is supported.
The value 'other' is used to indicate other means. | column | Enumeration | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.8 |
| docsIfMCmtsDepiSessionConfigTSID The TSID to be associated to the DEPI Session.
TSID is a 16-bit unsigned integer value configured per QAM
channel in the EQAM device and serves as a QAM channel
identifier at sev… | column | Unsigned32 | .1.3.6.1.4.1.4491.2.1.6.1.4.1.1.1.9 |