multiIfMainOperStatus – DLINK-DXS-1210-10TS-AX-MIB

Object

column Enumeration

The current operational state of the interface.
The testing (3) state indicates that no operational
packets can be passed - this state is not supported
currently. 
              
If ifMainAdminStatus is down (2)
then ifMainOperStatus would be down (2). If
ifMainAdminStatus is changed to up (1) then
ifMainOperStatus should change to up (1) if the
interface is ready to transmit and receive
work traffic; it should change to dormant (5)
the interface is waiting for external actions
(such as a serial line waiting for an incoming
connection); it should change to lowerLayerDown(7)
state if it cannot be made up as the interface sub-layer
below it is down; it should remain in the down (2) state
if and only if there is a fault that prevents it
from going to the up (1) state; it should remain in
the notPresent (6) state if the interface has
missing (typically, hardware) components.
              
The status unknown(4) is shown when it is not possible
to determine the exact status of the interface - e.g.
the interface sub-layer is performing negotiations - 
during this period the interface is not up but at the
same time, it is not a fault condition and hence it
cannot be shown as down - in such periods the status
is shown as unknown.
              
This object has the semantics of the ifOperStatus of the
standard ifTable.

Context

MIB: DLINK-DXS-1210-10TS-AX-MIB
OID: .1.3.6.1.4.1.171.10.139.2.1.5.3.1.1.3
Type: column
Access: readonly
Status: current
Parent: multiIfMainEntry
Table: multiIfMainTable
Siblings: 5

Syntax

Enumeration

Values & Constraints

Enumerated Values

`1`	up
`2`	down
`3`	testing
`4`	unknown
`5`	dormant
`6`	notPresent
`7`	lowerLayerDown

Related Objects

Sibling Objects

Object	Type	Syntax	OID
multiIfMainIndex A unique value, greater than zero, for each interface. This object is identical to the ifIndex of the standard MIB-2 ifTable.	column	IF-MIBInterfaceIndex	`.1.3.6.1.4.1.171.10.139.2.1.5.3.1.1.1`
multiIfMainAdminStatus The desired state of the interface. This object can be set only when the ifMainRowStatus of the interface is active. This object has the semantics of the ifAdminStatus of the stan…	column	Enumeration	`.1.3.6.1.4.1.171.10.139.2.1.5.3.1.1.2`
multiIfIpBindVlanId the IP Interface over the Vlan Interface which it vlan id is the configure Vlan id.	column	SNMPv2-SMIInteger32	`.1.3.6.1.4.1.171.10.139.2.1.5.3.1.1.4`
multiL3VlanIfName the L3 Vlan Interface Name.	column	OctetString	`.1.3.6.1.4.1.171.10.139.2.1.5.3.1.1.5`
multiIfMainRowStatus A RowStatus variable for addition, deletion and in-activation of the interfaces. Specification of the object is mandatory for all interfaces. When the status is act…	column	SNMPv2-TCRowStatus	`.1.3.6.1.4.1.171.10.139.2.1.5.3.1.1.6`