sfpsBlockSourceAPIVerb

Other -- N/A
Disable -- disable the source blocker (nodes that are currently 
 blocked will remain blocked, but no additional nodes will be blocked)
Enable -- enable the source blocker (allow it to start blocking nodes)
ClearAll -- clear the entire block table (this does not remove any 
 connection filters, and should only be used as a diagnostic tool.)
BlockMac -- administratively block a node (The node's MAC address
 must be previously set in the MAC leaf.)
UnblockMac -- administratively unblock a node (The node's MAC address
 must be previously set in the MAC leaf.)
SetMacUnblockable -- administratively mark a node as 'unblockable' 
 so that it cannot be blocked. (The node's MAC must be previously set 
 in the MAC leaf.) If the relevant node is blocked at the time the 
SetMacUnblockable command is issued, the node will automatically be
 'unblocked' first.
SetMacBlockable -- administratively mark a node as 'blockable' so that 
 it can be blocked. (The node's MAC must be previously set in the MAC
 leaf.)
SetPortUnblockable -- administratively mark a port as 'unblockable' so
 that any nodes on that port cannot be blocked. (The port number must
 be previously set in the Port leaf.)
SetPortBlockable -- administratively mark a port as 'blockable' so that
 all nodes on that port can be blocked. (The port number must be
 previously set in the Port leaf.)
SetReapUserCnx -- administratively mark a port as 'blocked' so that administratively
 mark a port as 'blockable' so that.)

MIB

CTRON-SFPS-BASE-MIB

OID

.1.3.6.1.4.1.52.4.2.4.2.2.14.4.1

Type

scalar

Access

readwrite

Status

mandatory