psEnvTemp

CTRON-ENVIRONMENT-MIB · .1.3.6.1.4.1.52.4.1.1.8.3.1.1.2
MIB view Table view

Object

column mandatory Integer32 
The temperature of the power supply. If this sensor is 
broken or not supported, then this object will be set to 
zero. The temperature is in degrees Fahrenheit * 10.

Context

MIB
CTRON-ENVIRONMENT-MIB
OID
.1.3.6.1.4.1.52.4.1.1.8.3.1.1.2
Type
column
Access
readonly
Status
mandatory
Parent
psEnvSlotEntry
Table
psEnvSlotTable
Siblings
9

Syntax

Integer32
Source
COPS-PR-SPPIInteger32
Base type
Integer32

Values & Constraints

Type Constraints
range: -2147483648..2147483647

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
psEnvSlotID mandatory
The slot number of a chassis slot in which this power supply is installed. An unique value, in the range between 1 and and the value of chNumSlots. This object is similiar to c…
columnInteger32.1.3.6.1.4.1.52.4.1.1.8.3.1.1.1
psEnvFanSpeed mandatory
The fan speed expressed as a percentage of the maximum fan speed.
columnInteger32.1.3.6.1.4.1.52.4.1.1.8.3.1.1.10
psEnvTempStatus mandatory
This object reflects the status of the power supply temperature reading.
columnEnumeration.1.3.6.1.4.1.52.4.1.1.8.3.1.1.3
psEnvTempHot mandatory
The temperature value above which the power supply temperature is deemed to be hot.
columnInteger32.1.3.6.1.4.1.52.4.1.1.8.3.1.1.4
psEnvTempWarm mandatory
The temperature value above which the power supply temperature is deemed to be warm, if it is below or equal the hot value.
columnInteger32.1.3.6.1.4.1.52.4.1.1.8.3.1.1.5
psEnvTempCool mandatory
The temperature value below which the power supply temperature is deemed to be cool, if it is above or equal the cold value.
columnInteger32.1.3.6.1.4.1.52.4.1.1.8.3.1.1.6
psEnvTempCold mandatory
The temperature value below which the power supply temperature is deemed to be cold.
columnInteger32.1.3.6.1.4.1.52.4.1.1.8.3.1.1.7
psEnvFanStatus mandatory
This object reflects the status of the chassis fan.
columnEnumeration.1.3.6.1.4.1.52.4.1.1.8.3.1.1.8
psEnvFanAdmin mandatory
This object is used to select the operational mode of the fan. If the value is set to 1 (auto) then fan speed is based on temperature. If the value is set to 3 (testing) then v…
columnEnumeration.1.3.6.1.4.1.52.4.1.1.8.3.1.1.9