upsLoadShedSecsWithRestart

CPQPOWER-MIB · .1.3.6.1.4.1.232.165.3.8.6
MIB view Table view

Object

scalar mandatory r/w Integer32 
Setting this value will cause the UPS output to turn off 
after the set number of seconds, then restart (after a UPS-defined
'down time') when the utility is again available.  
Unlike UpsControlOutputOffDelay, which might or might not,
this object always maps to the XCP 0x8A Load Dump & Restart command,
so the desired shutdown and restart behavior is guaranteed to happen.
Once set, this command cannot be aborted.
This is the preferred Control object to use when performing an On
Battery OS Shutdown.

Context

MIB
CPQPOWER-MIB
OID
.1.3.6.1.4.1.232.165.3.8.6
Type
scalar
Access
readwrite
Status
mandatory
Parent
upsControl
Siblings
5

Syntax

Integer32

Values & Constraints

Object Constraints
range: 0-2147483647

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
upsControlOutputOffDelay mandatory
Setting this value to other than zero will cause the UPS output to turn off after the number of seconds. Setting it to 0 will cause an attempt to abort a pending shutdown.
scalarInteger32.1.3.6.1.4.1.232.165.3.8.1
upsControlOutputOnDelay mandatory
Setting this value to other than zero will cause the UPS output to turn on after the number of seconds. Setting it to 0 will cause an attempt to abort a pending startup.
scalarInteger32.1.3.6.1.4.1.232.165.3.8.2
upsControlOutputOffTrapDelay mandatory
When UpsControlOutputOffDelay reaches this value, a trap will be sent.
scalarInteger32.1.3.6.1.4.1.232.165.3.8.3
upsControlOutputOnTrapDelay obsolete
When UpsControlOutputOnDelay reaches this value, a UpsOutputOff trap will be sent.
scalarInteger32.1.3.6.1.4.1.232.165.3.8.4
upsControlToBypassDelay mandatory
Setting this value to other than zero will cause the UPS output to go to Bypass after the number of seconds. If the Bypass is unavailable, this may cause the UPS to not supply…
scalarInteger32.1.3.6.1.4.1.232.165.3.8.5