upsControlToBypassDelay

CPQPOWER-MIB · .1.3.6.1.4.1.232.165.3.8.5
MIB view Table view

Object

scalar mandatory r/w Integer32 
Setting this value to other than zero will cause the UPS
output to go to Bypass after the number of seconds.
	 If the Bypass is unavailable, this may cause the UPS
	 to not supply power to the load.
Setting it to 0 will cause an attempt to abort a pending
shutdown.

Context

MIB
CPQPOWER-MIB
OID
.1.3.6.1.4.1.232.165.3.8.5
Type
scalar
Access
readwrite
Status
mandatory
Parent
upsControl
Siblings
5

Syntax

Integer32

Values & Constraints

Object Constraints
range: 0-2147483647

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
upsControlOutputOffDelay mandatory
Setting this value to other than zero will cause the UPS output to turn off after the number of seconds. Setting it to 0 will cause an attempt to abort a pending shutdown.
scalarInteger32.1.3.6.1.4.1.232.165.3.8.1
upsControlOutputOnDelay mandatory
Setting this value to other than zero will cause the UPS output to turn on after the number of seconds. Setting it to 0 will cause an attempt to abort a pending startup.
scalarInteger32.1.3.6.1.4.1.232.165.3.8.2
upsControlOutputOffTrapDelay mandatory
When UpsControlOutputOffDelay reaches this value, a trap will be sent.
scalarInteger32.1.3.6.1.4.1.232.165.3.8.3
upsControlOutputOnTrapDelay obsolete
When UpsControlOutputOnDelay reaches this value, a UpsOutputOff trap will be sent.
scalarInteger32.1.3.6.1.4.1.232.165.3.8.4
upsLoadShedSecsWithRestart mandatory
Setting this value will cause the UPS output to turn off after the set number of seconds, then restart (after a UPS-defined 'down time') when the utility is again available. Un…
scalarInteger32.1.3.6.1.4.1.232.165.3.8.6