cmdot11WifiNSideBand – CM-dot11plus-MIB

Object

column r/w Enumeration

When bonded channels (40 MHz) are used this object specifies if the
control (primary) channel is in the lower or upper 20 MHz band of the
bonded 40 MHz channel. Returns none(0) when cmdot11WifiNBandWidth != 40MHz.
Note: This MIB object is only valid for products supporting 802.11n and
only applies when cmdot11NBandWidth is set to 20/40MHz.

Context

MIB: CM-dot11plus-MIB
OID: .1.3.6.1.4.1.1166.1.19.51.1.5.2.3.1.5
Type: column
Access: readwrite
Status: current
Parent: cmdot11nEntry
Table: cmdot11nTable
Siblings: 5

Syntax

Enumeration

Values & Constraints

Enumerated Values

`0`	none
`1`	upper
`2`	lower

Related Objects

Sibling Objects

Object	Type	Syntax	OID
cmdot11WifiNMode Used to enable/disable 802.11n operation. 'Auto' is used to enable 802.11n operation; the Access Point will detect which stations are out there and operate in the proper mode. '…	column	Enumeration	`.1.3.6.1.4.1.1166.1.19.51.1.5.2.3.1.1`
cmdot11WifiNPhyRate Used to specify the 802.11n PHY transmission rate. 'Auto' is used to allow the Access Point to dynamically adapt to the environment and transmit using the fastest data rate for …	column	Enumeration	`.1.3.6.1.4.1.1166.1.19.51.1.5.2.3.1.2`
cmdot11WifiNBand Selects the wireless frequency band (2.4 GHz or 5 GHz) the Access Point will operate in. Note: This MIB object is only valid for products supporting 802.11n.	column	Enumeration	`.1.3.6.1.4.1.1166.1.19.51.1.5.2.3.1.3`
cmdot11WifiNBandWidth Specifies the channel width (20 MHz or 20/40 MHz) to be used by the Access Point. When 20/40MHz is selected 802.11n clients experience improved throughput using 40 MHz, while lega…	column	Enumeration	`.1.3.6.1.4.1.1166.1.19.51.1.5.2.3.1.4`
cmdot11WifiNProtection Determines if protection will be turned on or off for 802.11n mode. When set to auto, the Access Point will enable protection to allow 802.11n clients to co-exist with 802.11a/b/g…	column	Enumeration	`.1.3.6.1.4.1.1166.1.19.51.1.5.2.3.1.6`