cxeCallCtrlT38NsfCountryCode
CISCO-XGCP-EXT-MIB ·
.1.3.6.1.4.1.9.9.325.1.1.1.1.17
Object
This object specifies the country code for identifying
the country where the media gateway with non-standard
capabilities was manufactured.
This object is not applicable if cxeCallCtrlT38Inhibited
is set to 'true'.
Context
- MIB
- CISCO-XGCP-EXT-MIB
- OID
.1.3.6.1.4.1.9.9.325.1.1.1.1.17- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- cxeCallCtrlConfigEntry
- Table
- cxeCallCtrlConfigTable
- Siblings
- 21
Values & Constraints
Type Constraints
range: 0..255
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cxeCallCtrlControlServiceType This object identifies Type Of Service (TOS) field of
IP header for the control packet in VoIP application. | column | Integer32 | .1.3.6.1.4.1.9.9.325.1.1.1.1.1 |
| cxeCallCtrlIgnoreAal2LcoCodec This object defines whether to ignore the AAL2 Local
Connection Option (LCO) message from the call agent
or not. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.325.1.1.1.1.10 |
| cxeCallCtrlDigitMapOrder This object defines the type of digit map order.
The MGC can advise and load the gateway with a digit map
that correspond to the dial plan to collect the access
codes, credit c… | column | Enumeration | .1.3.6.1.4.1.9.9.325.1.1.1.1.11 |
| cxeCallCtrlT38Inhibited This object defines whether T.38 is inhibited in the
media gateway or not.
T.38 is a Fax Relay Protocol defined by ITU for
real-time protocol for Fax over IP netw… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.325.1.1.1.1.12 |
| cxeCallCtrlT38NseRspTimer This object defines a timeout value for a timer.
This timer is started after sending a NSE 200
while waiting for the NSE 201 acknowledgement or
NSE 202 negative acknowledgement.… | column | milliseconds Integer32 | .1.3.6.1.4.1.9.9.325.1.1.1.1.13 |
| cxeCallCtrlT38FecEnabled This object is used to enable the Forward Error
Correction (FEC) for UDP-based fax transport.
This object is not applicable if cxeCallCtrlT38Inhibited
is set to '… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.325.1.1.1.1.14 |
| cxeCallCtrlT38LsRedundancy This object determines the extent of the Internet Fax
Protocol (IFP) packet transmission redundancy for
the low-speed control information exchanged during
the first phase of a T… | column | Integer32 | .1.3.6.1.4.1.9.9.325.1.1.1.1.15 |
| cxeCallCtrlT38HsRedundancy This object determines the extent of the Internet Fax
Protocol (IFP) packet transmission redundancy for
the high-speed control and image information
exchanged following the init… | column | Integer32 | .1.3.6.1.4.1.9.9.325.1.1.1.1.16 |
| cxeCallCtrlT38NsfVendorCode Per its definition (ITU T.35), the Vendor Code (also
called the Terminal Provider Code) in the Non-Standard
Facilities (NSF) code is a two-byte field identifying the
manufacturer … | column | CxeTerminalProviderCode | .1.3.6.1.4.1.9.9.325.1.1.1.1.18 |
| cxeCallCtrlVselDselFselSupport This object is used to enable or disable VSEL, DSEL and
FSEL support.
VSEL: Voice codec, packet length and packet times Selection
DSEL: Data codec, packet length… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.325.1.1.1.1.19 |
| cxeCallCtrlBearerServiceType This object identifies Type Of Service (TOS) field
of IP header for the voice payload packet in VoIP
application. | column | Integer32 | .1.3.6.1.4.1.9.9.325.1.1.1.1.2 |
| cxeCallCtrlDefaultBearTraffic This object specifies the combination of the network
type (IP/ATM), virtual circuit type (PVC/SVC) and
ATM adaptation layer type (AAL1/AAL2/AAL5) for the
connection used in tran… | column | Enumeration | .1.3.6.1.4.1.9.9.325.1.1.1.1.20 |
| cxeCallCtrlLastFailedMgcAddrType This object indicates the address type, either IPv4 or
IPv6, of cxeCallCtrlLastFailedMgcAddress. | column | INET-ADDRESS-MIBInetAddressType | .1.3.6.1.4.1.9.9.325.1.1.1.1.21 |
| cxeCallCtrlLastFailedMgcAddress This object indicates the address of MGC (Media Gateway
Controller) with which the media gateway had tried to
communicate lastly but failed. | column | INET-ADDRESS-MIBInetAddress | .1.3.6.1.4.1.9.9.325.1.1.1.1.22 |
| cxeCallCtrlVoIpDtmfRelayMode This object defines whether the DTMF (Dual Tone,
Multi-Frequency) digits need to be transported to the other
endpoint via NSE packets in Voice Over IP.
The value o… | column | DtmfRelayMode | .1.3.6.1.4.1.9.9.325.1.1.1.1.3 |
| cxeCallCtrlVoIpDtmfCodec This object identifies DTMF relay codec for VoIP.
This object is not applicable if cxeCallCtrlVoIpDtmfRelay
is DtmfRelayDisabled. | column | DtmfCodecType | .1.3.6.1.4.1.9.9.325.1.1.1.1.4 |
| cxeCallCtrlVoAal2DtmfRelayMode This object defines whether the DTMF (Dual Tone,
Multi-Frequency) digits need to be transported to the other
endpoint in Voice over AAL2 packets.
The value of this… | column | DtmfRelayMode | .1.3.6.1.4.1.9.9.325.1.1.1.1.5 |
| cxeCallCtrlVoAal2DtmfCodec This object identifies DTMF relay CODEC for Voice over AAL2.
This object is not applicable if cxeCallCtrlVoAal2DtmfRelay
is DtmfRelayDisabled. | column | DtmfCodecType | .1.3.6.1.4.1.9.9.325.1.1.1.1.6 |
| cxeCallCtrlTsePayload This object identifies TSE (Telephony Signaling
Events) payload type. | column | Integer32 | .1.3.6.1.4.1.9.9.325.1.1.1.1.7 |
| cxeCallCtrlNetNseTimer This object identifies Network Signaling Event (NSE)
timeout value. | column | milliseconds Integer32 | .1.3.6.1.4.1.9.9.325.1.1.1.1.8 |
| cxeCallCtrlRtcpRcvTimer This object identifies the number of times of Real Time
Control Transport (RTCP) report interval if the media
gateway has not recieved any RTCP packets from another
side.
… | column | times Integer32 | .1.3.6.1.4.1.9.9.325.1.1.1.1.9 |