cxeCallCtrlT38LsRedundancy

CISCO-XGCP-EXT-MIB · .1.3.6.1.4.1.9.9.325.1.1.1.1.15
MIB view Table view

Object

column r/w Integer32 
This object determines the extent of the Internet Fax
Protocol (IFP) packet transmission redundancy for 
the low-speed control information exchanged during 
the first phase of a T.38 fax relay connection.
              
Depending on whether Forward Error Correction (FEC) 
is enabled (cxeCallCtrlT38FecEnabled is set to 'true') 
or not, this object has different meanings.
If FEC is disabled, then this object is the maximum 
number of prior IFP packets within a Unnumbered
Datagram Protocol Transport Layer (UDPTL) packet carrying
low speed information, not counting the primary or 
current IFP packet.
              
If FEC is enabled, then this object is the maximum
number of FEC messages within a UDPTL packet carrying 
low speed information.
              
This object is not applicable if cxeCallCtrlT38Inhibited 
is set to 'true'.

Context

MIB
CISCO-XGCP-EXT-MIB
OID
.1.3.6.1.4.1.9.9.325.1.1.1.1.15
Type
column
Access
readwrite
Status
current
Parent
cxeCallCtrlConfigEntry
Table
cxeCallCtrlConfigTable
Siblings
21

Syntax

Integer32

Values & Constraints

Object Constraints
range: 0-5

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
cxeCallCtrlControlServiceType
This object identifies Type Of Service (TOS) field of IP header for the control packet in VoIP application.
columnInteger32.1.3.6.1.4.1.9.9.325.1.1.1.1.1
cxeCallCtrlIgnoreAal2LcoCodec
This object defines whether to ignore the AAL2 Local Connection Option (LCO) message from the call agent or not.
columnSNMPv2-TCTruthValue.1.3.6.1.4.1.9.9.325.1.1.1.1.10
cxeCallCtrlDigitMapOrder
This object defines the type of digit map order. The MGC can advise and load the gateway with a digit map that correspond to the dial plan to collect the access codes, credit c…
columnEnumeration.1.3.6.1.4.1.9.9.325.1.1.1.1.11
cxeCallCtrlT38Inhibited
This object defines whether T.38 is inhibited in the media gateway or not. T.38 is a Fax Relay Protocol defined by ITU for real-time protocol for Fax over IP netw…
columnSNMPv2-TCTruthValue.1.3.6.1.4.1.9.9.325.1.1.1.1.12
cxeCallCtrlT38NseRspTimer
This object defines a timeout value for a timer. This timer is started after sending a NSE 200 while waiting for the NSE 201 acknowledgement or NSE 202 negative acknowledgement.…
columnmilliseconds Integer32.1.3.6.1.4.1.9.9.325.1.1.1.1.13
cxeCallCtrlT38FecEnabled
This object is used to enable the Forward Error Correction (FEC) for UDP-based fax transport. This object is not applicable if cxeCallCtrlT38Inhibited is set to '…
columnSNMPv2-TCTruthValue.1.3.6.1.4.1.9.9.325.1.1.1.1.14
cxeCallCtrlT38HsRedundancy
This object determines the extent of the Internet Fax Protocol (IFP) packet transmission redundancy for the high-speed control and image information exchanged following the init…
columnInteger32.1.3.6.1.4.1.9.9.325.1.1.1.1.16
cxeCallCtrlT38NsfCountryCode
This object specifies the country code for identifying the country where the media gateway with non-standard capabilities was manufactured. This object is not appl…
columnCISCO-TCCountryCodeITU.1.3.6.1.4.1.9.9.325.1.1.1.1.17
cxeCallCtrlT38NsfVendorCode
Per its definition (ITU T.35), the Vendor Code (also called the Terminal Provider Code) in the Non-Standard Facilities (NSF) code is a two-byte field identifying the manufacturer …
columnCxeTerminalProviderCode.1.3.6.1.4.1.9.9.325.1.1.1.1.18
cxeCallCtrlVselDselFselSupport
This object is used to enable or disable VSEL, DSEL and FSEL support. VSEL: Voice codec, packet length and packet times Selection DSEL: Data codec, packet length…
columnSNMPv2-TCTruthValue.1.3.6.1.4.1.9.9.325.1.1.1.1.19
cxeCallCtrlBearerServiceType
This object identifies Type Of Service (TOS) field of IP header for the voice payload packet in VoIP application.
columnInteger32.1.3.6.1.4.1.9.9.325.1.1.1.1.2
cxeCallCtrlDefaultBearTraffic
This object specifies the combination of the network type (IP/ATM), virtual circuit type (PVC/SVC) and ATM adaptation layer type (AAL1/AAL2/AAL5) for the connection used in tran…
columnEnumeration.1.3.6.1.4.1.9.9.325.1.1.1.1.20
cxeCallCtrlLastFailedMgcAddrType
This object indicates the address type, either IPv4 or IPv6, of cxeCallCtrlLastFailedMgcAddress.
columnINET-ADDRESS-MIBInetAddressType.1.3.6.1.4.1.9.9.325.1.1.1.1.21
cxeCallCtrlLastFailedMgcAddress
This object indicates the address of MGC (Media Gateway Controller) with which the media gateway had tried to communicate lastly but failed.
columnINET-ADDRESS-MIBInetAddress.1.3.6.1.4.1.9.9.325.1.1.1.1.22
cxeCallCtrlVoIpDtmfRelayMode
This object defines whether the DTMF (Dual Tone, Multi-Frequency) digits need to be transported to the other endpoint via NSE packets in Voice Over IP. The value o…
columnDtmfRelayMode.1.3.6.1.4.1.9.9.325.1.1.1.1.3
cxeCallCtrlVoIpDtmfCodec
This object identifies DTMF relay codec for VoIP. This object is not applicable if cxeCallCtrlVoIpDtmfRelay is DtmfRelayDisabled.
columnDtmfCodecType.1.3.6.1.4.1.9.9.325.1.1.1.1.4
cxeCallCtrlVoAal2DtmfRelayMode
This object defines whether the DTMF (Dual Tone, Multi-Frequency) digits need to be transported to the other endpoint in Voice over AAL2 packets. The value of this…
columnDtmfRelayMode.1.3.6.1.4.1.9.9.325.1.1.1.1.5
cxeCallCtrlVoAal2DtmfCodec
This object identifies DTMF relay CODEC for Voice over AAL2. This object is not applicable if cxeCallCtrlVoAal2DtmfRelay is DtmfRelayDisabled.
columnDtmfCodecType.1.3.6.1.4.1.9.9.325.1.1.1.1.6
cxeCallCtrlTsePayload
This object identifies TSE (Telephony Signaling Events) payload type.
columnInteger32.1.3.6.1.4.1.9.9.325.1.1.1.1.7
cxeCallCtrlNetNseTimer
This object identifies Network Signaling Event (NSE) timeout value.
columnmilliseconds Integer32.1.3.6.1.4.1.9.9.325.1.1.1.1.8
cxeCallCtrlRtcpRcvTimer
This object identifies the number of times of Real Time Control Transport (RTCP) report interval if the media gateway has not recieved any RTCP packets from another side. …
columntimes Integer32.1.3.6.1.4.1.9.9.325.1.1.1.1.9