cxeCallCtrlDefaultBearTraffic
CISCO-XGCP-EXT-MIB ·
.1.3.6.1.4.1.9.9.325.1.1.1.1.20
Object
column
r/w
Enumeration
This object specifies the combination of the network
type (IP/ATM), virtual circuit type (PVC/SVC) and
ATM adaptation layer type (AAL1/AAL2/AAL5) for the
connection used in transporting bearer traffic.
ipPvcAal5 (1) - The bearer traffic is transported in
IP network, through Permanent Virtual
Circuit(PVC) over AAL5 adaptation layer.
atmPvcAal2 (2) - The bearer traffic is transported in
ATM network, through Permanent Virtual
Circuit(PVC) over AAL2 adaptation layer.
atmSvcAal2 (3) - The bearer traffic is transported in
ATM network, through Switching Virtual
Circuit(SVC) over AAL2 adaptation layer.
atmSvcAal1 (4) - The bearer traffic is transported in
ATM network, through Switching Virtual
Circuit(SVC) over AAL1 adaptation layer.
If the call agent specifies the bear traffic type in the
MGCP (Media Gateway Control Protocol) local connection
options (CRCX request), then configuration of this object
will have no effect, else the value of this object will be
used when sending CRCX response.
Context
- MIB
- CISCO-XGCP-EXT-MIB
- OID
.1.3.6.1.4.1.9.9.325.1.1.1.1.20- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- cxeCallCtrlConfigEntry
- Table
- cxeCallCtrlConfigTable
- Siblings
- 21
Syntax
Enumeration
Values & Constraints
Enumerated Values
1 | ipPvcAal5 |
2 | atmPvcAal2 |
3 | atmSvcAal2 |
4 | atmSvcAal1 |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cxeCallCtrlControlServiceType This object identifies Type Of Service (TOS) field of
IP header for the control packet in VoIP application. | column | Integer32 | .1.3.6.1.4.1.9.9.325.1.1.1.1.1 |
| cxeCallCtrlIgnoreAal2LcoCodec This object defines whether to ignore the AAL2 Local
Connection Option (LCO) message from the call agent
or not. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.325.1.1.1.1.10 |
| cxeCallCtrlDigitMapOrder This object defines the type of digit map order.
The MGC can advise and load the gateway with a digit map
that correspond to the dial plan to collect the access
codes, credit c… | column | Enumeration | .1.3.6.1.4.1.9.9.325.1.1.1.1.11 |
| cxeCallCtrlT38Inhibited This object defines whether T.38 is inhibited in the
media gateway or not.
T.38 is a Fax Relay Protocol defined by ITU for
real-time protocol for Fax over IP netw… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.325.1.1.1.1.12 |
| cxeCallCtrlT38NseRspTimer This object defines a timeout value for a timer.
This timer is started after sending a NSE 200
while waiting for the NSE 201 acknowledgement or
NSE 202 negative acknowledgement.… | column | milliseconds Integer32 | .1.3.6.1.4.1.9.9.325.1.1.1.1.13 |
| cxeCallCtrlT38FecEnabled This object is used to enable the Forward Error
Correction (FEC) for UDP-based fax transport.
This object is not applicable if cxeCallCtrlT38Inhibited
is set to '… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.325.1.1.1.1.14 |
| cxeCallCtrlT38LsRedundancy This object determines the extent of the Internet Fax
Protocol (IFP) packet transmission redundancy for
the low-speed control information exchanged during
the first phase of a T… | column | Integer32 | .1.3.6.1.4.1.9.9.325.1.1.1.1.15 |
| cxeCallCtrlT38HsRedundancy This object determines the extent of the Internet Fax
Protocol (IFP) packet transmission redundancy for
the high-speed control and image information
exchanged following the init… | column | Integer32 | .1.3.6.1.4.1.9.9.325.1.1.1.1.16 |
| cxeCallCtrlT38NsfCountryCode This object specifies the country code for identifying
the country where the media gateway with non-standard
capabilities was manufactured.
This object is not appl… | column | CISCO-TCCountryCodeITU | .1.3.6.1.4.1.9.9.325.1.1.1.1.17 |
| cxeCallCtrlT38NsfVendorCode Per its definition (ITU T.35), the Vendor Code (also
called the Terminal Provider Code) in the Non-Standard
Facilities (NSF) code is a two-byte field identifying the
manufacturer … | column | CxeTerminalProviderCode | .1.3.6.1.4.1.9.9.325.1.1.1.1.18 |
| cxeCallCtrlVselDselFselSupport This object is used to enable or disable VSEL, DSEL and
FSEL support.
VSEL: Voice codec, packet length and packet times Selection
DSEL: Data codec, packet length… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.325.1.1.1.1.19 |
| cxeCallCtrlBearerServiceType This object identifies Type Of Service (TOS) field
of IP header for the voice payload packet in VoIP
application. | column | Integer32 | .1.3.6.1.4.1.9.9.325.1.1.1.1.2 |
| cxeCallCtrlLastFailedMgcAddrType This object indicates the address type, either IPv4 or
IPv6, of cxeCallCtrlLastFailedMgcAddress. | column | INET-ADDRESS-MIBInetAddressType | .1.3.6.1.4.1.9.9.325.1.1.1.1.21 |
| cxeCallCtrlLastFailedMgcAddress This object indicates the address of MGC (Media Gateway
Controller) with which the media gateway had tried to
communicate lastly but failed. | column | INET-ADDRESS-MIBInetAddress | .1.3.6.1.4.1.9.9.325.1.1.1.1.22 |
| cxeCallCtrlVoIpDtmfRelayMode This object defines whether the DTMF (Dual Tone,
Multi-Frequency) digits need to be transported to the other
endpoint via NSE packets in Voice Over IP.
The value o… | column | DtmfRelayMode | .1.3.6.1.4.1.9.9.325.1.1.1.1.3 |
| cxeCallCtrlVoIpDtmfCodec This object identifies DTMF relay codec for VoIP.
This object is not applicable if cxeCallCtrlVoIpDtmfRelay
is DtmfRelayDisabled. | column | DtmfCodecType | .1.3.6.1.4.1.9.9.325.1.1.1.1.4 |
| cxeCallCtrlVoAal2DtmfRelayMode This object defines whether the DTMF (Dual Tone,
Multi-Frequency) digits need to be transported to the other
endpoint in Voice over AAL2 packets.
The value of this… | column | DtmfRelayMode | .1.3.6.1.4.1.9.9.325.1.1.1.1.5 |
| cxeCallCtrlVoAal2DtmfCodec This object identifies DTMF relay CODEC for Voice over AAL2.
This object is not applicable if cxeCallCtrlVoAal2DtmfRelay
is DtmfRelayDisabled. | column | DtmfCodecType | .1.3.6.1.4.1.9.9.325.1.1.1.1.6 |
| cxeCallCtrlTsePayload This object identifies TSE (Telephony Signaling
Events) payload type. | column | Integer32 | .1.3.6.1.4.1.9.9.325.1.1.1.1.7 |
| cxeCallCtrlNetNseTimer This object identifies Network Signaling Event (NSE)
timeout value. | column | milliseconds Integer32 | .1.3.6.1.4.1.9.9.325.1.1.1.1.8 |
| cxeCallCtrlRtcpRcvTimer This object identifies the number of times of Real Time
Control Transport (RTCP) report interval if the media
gateway has not recieved any RTCP packets from another
side.
… | column | times Integer32 | .1.3.6.1.4.1.9.9.325.1.1.1.1.9 |