p2mpLocalLoopbackMode – CISCO-WIRELESS-P2MP-PHY-MIB

Object

column r/w Enumeration

This object is used to configure the system in loopback mode 
prior to executing some system diagnostic tests.  The user 
selects the point in the system where the data signal should be
looped back.  The diagnostic tests outlined in the user manual
have to be manually executed to determine success or failure.  
Once all the tests are completed, normal operation is restored
by setting this object to noLoopback(1).
              
noLoopback(1)  - no loopback
fir(2)         - loopback at the Finite Impulse 
                 Response (FIR) module.
if(3)          - loopback at the IF module.  This 
                 exercises the FIR, and IF modules.
rf(4)          - loopback at the RF unit. This 
                 exercises the FIR, IF, and RF modules.
                 This mode is supported only when
                 p2mpRfLoopbackSupported is true(1).

Context

MIB: CISCO-WIRELESS-P2MP-PHY-MIB
OID: .1.3.6.1.4.1.9.9.170.1.1.3.1.1.1
Type: column
Access: readwrite
Status: current
Parent: p2mpLoopbackEntry
Table: p2mpLoopbackTable
Siblings: 2

Syntax

Enumeration

Values & Constraints

Enumerated Values

`1`	noLoopback
`2`	fir
`3`	if
`4`	rf

Related Objects

Sibling Objects

Object	Type	Syntax	OID
p2mpLocalLoopbackAntenna This object identifies the RF resource used for loopback testing. This object is not applicable for loopback testing when p2mpLocalLoopbackMode has a value of 'noLoopback(1)'.	column	CISCO-WIRELESS-TC-MIBCwrRfType	`.1.3.6.1.4.1.9.9.170.1.1.3.1.1.2`
p2mpLocalLoopbackChannel This object identifies the channel being used to loopback the data. This object is not applicable for loopback testing when p2mpLocalLoopbackMode has a value of 'noLoopback(1…	column	Unsigned32	`.1.3.6.1.4.1.9.9.170.1.1.3.1.1.3`