cvIfCfgConnectionMode
CISCO-VOICE-IF-MIB ·
.1.3.6.1.4.1.9.9.64.1.1.1.1.8
Object
column
r/w
Enumeration
The object indicates the connection mode of the interface.
normal - the interface acts normally to handle incoming
and outgoing call.
trunk - the interface acts in trunking mode. trunking mode
causes two interfaces (on either the same or
different routers) to be always conferenced
together, and for telephony signaling to be passed
transparently through the VoIP system rather than
trapped and interpreted by the session application
on the router(s).
plar - the interface acts in PLAR (private line automatic
ringdown) mode. PLAR is handled by associating a
peer directly with an interface such that when the
interface goes off-hook, that peer is used to
setup the second call leg and conference them
together without the caller having to dial any
digits.
tieline- the interface acts in tie-line mode. This
specifies a connection that emulates a temporary
tie-line trunk to a PBX. A tie-line connection is
automatically set up for each call and torn down
when the call ends.
Context
- MIB
- CISCO-VOICE-IF-MIB
- OID
.1.3.6.1.4.1.9.9.64.1.1.1.1.8- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- cvIfCfgEntry
- Table
- cvIfCfgTable
- Siblings
- 13
Syntax
Enumeration
Values & Constraints
Enumerated Values
1 | normal |
2 | trunk |
3 | plar |
4 | tieline |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cvIfCfgNoiseRegEnable The object indicates whether or not the background noise
should be played to fill silence gaps if VAD is
activated.
The default value of this object is enabled. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.64.1.1.1.1.1 |
| cvIfCfgInitialDigitTimeOut This is the initial digit timeout that indicates the amount
of time the managed system waits for an initial input digit
from the caller. The timer is activated when the call is
ac… | column | seconds Integer32 | .1.3.6.1.4.1.9.9.64.1.1.1.1.10 |
| cvIfCfgInterDigitTimeOut This is the inter-digit timeout that indicates the amount
of time the managed system waits for a subsequent input
digit from the caller. The timer is started upon receipt
of an in… | column | seconds Integer32 | .1.3.6.1.4.1.9.9.64.1.1.1.1.11 |
| cvIfCfgRegionalTone This object contains the country specific setting
for the tone, ring, cadence parameters to be used by
this interface. | column | CISCO-TCCountryCode | .1.3.6.1.4.1.9.9.64.1.1.1.1.12 |
| cvIfCfgEchoCancelWorstERL The object specifies the worst case Echo Return Loss for
which the echo canceller must operate. To some echo
cancellers this object may not apply. This object is
valid if the c… | column | Enumeration | .1.3.6.1.4.1.9.9.64.1.1.1.1.13 |
| cvIfCfgEchoCanceller The object specifies which echo canceller is present
on the interface.
echoCancellerStandard - for this echo canceller valid
values of cvIfCfgEchoCancelCoverage are echoCanceller8… | column | Enumeration | .1.3.6.1.4.1.9.9.64.1.1.1.1.14 |
| cvIfCfgNonLinearProcEnable The object indicates whether or not the Nonlinear
Processing is enabled for the interface.
The default value of this object is enabled. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.64.1.1.1.1.2 |
| cvIfCfgMusicOnHoldThreshold The object specifies the Music On Hold Threshold for
the interface.
The default value of this object is -38 dBm. | column | dBm Integer32 | .1.3.6.1.4.1.9.9.64.1.1.1.1.3 |
| cvIfCfgInGain This object contains the amount of gain inserted at the
receiver side of the interface. The input gain settings
only define a gain/loss relative to the 0 dB setting.
The absolute … | column | dB Integer32 | .1.3.6.1.4.1.9.9.64.1.1.1.1.4 |
| cvIfCfgOutAttn This object contains the amount of attenuation inserted
at the transmit side of the interface.
The output attenuation settings only define a loss
relative to the 0 dB setting.
T… | column | dB Integer32 | .1.3.6.1.4.1.9.9.64.1.1.1.1.5 |
| cvIfCfgEchoCancelEnable The object specifies whether or not the Echo Cancellation
is enabled for the interface.
The default value of this object is enabled. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.64.1.1.1.1.6 |
| cvIfCfgEchoCancelCoverage The object specifies the Echo Canceller coverage for
the interface. This object is valid if the
cvIfCfgEchoCancelEnable object is 'true'.
echoCanceller8ms - 8 millisecs echo c… | column | Enumeration | .1.3.6.1.4.1.9.9.64.1.1.1.1.7 |
| cvIfCfgConnectionNumber This is the E.164 phone number that is used to
establish connection with trunking mode or PLAR mode.
If the cvIfCfgConnectionMode is 'normal', then this
object will be a zero le… | column | OctetString | .1.3.6.1.4.1.9.9.64.1.1.1.1.9 |