cvaIfEMCfgSignalType

The signaling type of E&M tie trunk interface.
winkStart - the calling side seizes the line by going
            off-hook on its E lead but waits for a short
            off-hook 'wink' indication on its M lead from
            the called side before sending address
            information as DTMF digits.
immediateDial - the calling side seizes the line by going
            off-hook on its E lead and sends sends address
            information as DTMF digits.
delayDial - the calling side seizes the line by going
            off-hook on its E lead. After a timing interval,
            the calling side looks at the supervision 
            from the called side. If the supervision is
            on-hook, the calling side starts sending
            information as DTMF digits; otherwise, the calling
            side waits until the called side goes
            on-hook and then starts sending address
            information.
lmr       - the e&m port is used to interface with
            Land Mobil Radio system. The e-lead and 
            m-lead are not used in the traditional
            way.
fgd       - Feature Group D is an access switched services
            that provides access to Local Exchange Carrier
            of the public switched network. It is supported
            in North America only based on E&M wink-start.
fgd-eana  - Exchange Access North American signalling
            protocol of Feature Group D.

MIB

CISCO-VOICE-ANALOG-IF-MIB

OID

.1.3.6.1.4.1.9.9.62.1.2.1.1.1

Type

column

Access

readwrite

Status

current

Parent

cvaIfEMCfgEntry

Table

cvaIfEMCfgTable

Siblings

6