cvaIfEMCfgLmrECap – CISCO-VOICE-ANALOG-IF-MIB

Object

column r/w Enumeration

The E lead behavior of E&M LMR interface.
seize - The e-lead used as seize signal
voice -  The e-lead status is used to indicate
         voice packet received or not.
inactive -- e-lead is inactive.

Context

MIB: CISCO-VOICE-ANALOG-IF-MIB
OID: .1.3.6.1.4.1.9.9.62.1.2.1.1.6
Type: column
Access: readwrite
Status: current
Parent: cvaIfEMCfgEntry
Table: cvaIfEMCfgTable
Siblings: 6

Syntax

Enumeration

Values & Constraints

Enumerated Values

`4`	seize
`5`	voice
`6`	inactive

Related Objects

Sibling Objects

Object	Type	Syntax	OID
cvaIfEMCfgSignalType The signaling type of E&M tie trunk interface. winkStart - the calling side seizes the line by going off-hook on its E lead but waits for a short off-hook …	column	Enumeration	`.1.3.6.1.4.1.9.9.62.1.2.1.1.1`
cvaIfEMCfgOperation Specify the operation of the E&M signal. twoWires - 2-wire operation. fourWires - 4-wire operation.	column	Enumeration	`.1.3.6.1.4.1.9.9.62.1.2.1.1.2`
cvaIfEMCfgType Specifies the E&M Lead Signaling type. LEGEND: V = -48V /\/\/ = detector/resister X = normally open relay contact + = normally closed relay contact G = ground SB …	column	Enumeration	`.1.3.6.1.4.1.9.9.62.1.2.1.1.3`
cvaIfEMCfgDialType Specifies the out dialing type of E&M interface.	column	InterfaceDialType	`.1.3.6.1.4.1.9.9.62.1.2.1.1.4`
cvaIfEMCfgLmrMCap The M lead behavior of E&M LMR interface. inact - The m-lead status should be ignored. audio - The m-lead status is used to control generating voice packet. dial - Perfo…	column	Enumeration	`.1.3.6.1.4.1.9.9.62.1.2.1.1.5`
cvaIfEMCfgAutoGainControl This object is used to enabling/disabling automatic gain control(AGC) on this interface. AGC allows DSP to adjust the input voice volume and avoid rapid voice volume change.	column	SNMPv2-TCTruthValue	`.1.3.6.1.4.1.9.9.62.1.2.1.1.7`