cvaIfEMCfgDialType
CISCO-VOICE-ANALOG-IF-MIB ·
.1.3.6.1.4.1.9.9.62.1.2.1.1.4
Object
column
r/w
InterfaceDialType
Specifies the out dialing type of E&M interface.
Context
- MIB
- CISCO-VOICE-ANALOG-IF-MIB
- OID
.1.3.6.1.4.1.9.9.62.1.2.1.1.4- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- cvaIfEMCfgEntry
- Table
- cvaIfEMCfgTable
- Siblings
- 6
Syntax
InterfaceDialType
- Source
- InterfaceDialType
- Base type
Enumeration
Values & Constraints
Type Values
1 | dtmf |
2 | pulse |
3 | mf |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cvaIfEMCfgSignalType The signaling type of E&M tie trunk interface.
winkStart - the calling side seizes the line by going
off-hook on its E lead but waits for a short
off-hook … | column | Enumeration | .1.3.6.1.4.1.9.9.62.1.2.1.1.1 |
| cvaIfEMCfgOperation Specify the operation of the E&M signal.
twoWires - 2-wire operation.
fourWires - 4-wire operation. | column | Enumeration | .1.3.6.1.4.1.9.9.62.1.2.1.1.2 |
| cvaIfEMCfgType Specifies the E&M Lead Signaling type.
LEGEND: V = -48V
/\/\/ = detector/resister
X = normally open relay contact
+ = normally closed relay contact
G = ground
SB … | column | Enumeration | .1.3.6.1.4.1.9.9.62.1.2.1.1.3 |
| cvaIfEMCfgLmrMCap The M lead behavior of E&M LMR interface.
inact - The m-lead status should be ignored.
audio - The m-lead status is used to control
generating voice packet.
dial - Perfo… | column | Enumeration | .1.3.6.1.4.1.9.9.62.1.2.1.1.5 |
| cvaIfEMCfgLmrECap The E lead behavior of E&M LMR interface.
seize - The e-lead used as seize signal
voice - The e-lead status is used to indicate
voice packet received or not.
inactive --… | column | Enumeration | .1.3.6.1.4.1.9.9.62.1.2.1.1.6 |
| cvaIfEMCfgAutoGainControl This object is used to enabling/disabling automatic
gain control(AGC) on this interface. AGC allows DSP
to adjust the input voice volume and avoid rapid
voice volume change. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.62.1.2.1.1.7 |